Abstract:The stress response behaviors of steel wires at the anchorage part of bridge cables under tension and bending coupling loads play a predominant role in determining their fatigue life and failure modes. The inherent complexity of the spiral geometry and the large diameter of actual bridge cables made the stress response behaviors of steel wires at the anchorage part unclear up to now. An analytical method was proposed for spiral steel wires at the anchorage part of semiparallel steel wire cables under tension and bending coupling loads. The corresponding refined numerical modeling method was also developed for studying the local anchorage part. Both the analytical formulation and numerical model agree well with the related experimental results in the literature. The presented analytical and numerical methods are thereby efficient and accurate to simulate bridge cables under tension and bending coupling loads. The critical slip curvature of steel wires increases linearly with the tensile strain of the bridge cable. The axial stresses of the steel wires of the bridge cable at a given longitudinal location display a linear relation with the angular change at the anchorage end. For steel wires located at the guide deviator part of the bridge cable, the axial stress behavior differs between the stick and slip states. It changes to a chord curve in the longitudinal direction in the stick state, while it follows an exponential function with respect to the polar angle in the slip state. The axial stress range of the outermost steel wire of the bridge cable increases linearly with the harmonic tension load range and the bending load range, separately. Regarding the phase difference between harmonic tension and bending coupling loads, a phase difference of 0 represents the most unfavorable combination for the bridge cable. By contrast, when the phase difference falls between 0 and π/2, the two harmonic loads tend to mutually inhibit each other’s effects on the cable’s behavior.

Validity and Limitation of Analytical Models for the Bending Stress of a Helical Wire in Unbonded Flexible Pipes

Helical Wire Behavior of Unbonded Flexible Pipes under Bending

Short-Term Mechanical Analysis of Polyethylene Pipe Reinforced by Winding Steel Wires Using Steel Wire Spiral Structural Finite Element Model

Static model and cross section characteristic analysis of steel strand

Alternative analytical and finite element models for unbonded flexible pipes under axisymmetric loads

Analytical Model for the Bending of Parallel Wire Cables Considering Interactions among Wires

Buckling Response of Offshore Pipelines under Combined Tension and Bending

A New Fully-Detailed Finite Element Model of Spiral Strand Wire Ropes for Fatigue Life Estimate of a Mooring Line

A Three-Dimensional Analytical Solution for Sandwich Pipe Systems under Linearly Varying External Pressures

Dynamic Analysis of Unbonded Flexible Pipe with Bend Stiffener Constraint and Bending Hysteretic Behavior

A Theoretical Study on Nonlinear Bending of Wires

A Finite Element Model for Prediction of the Bending Stress of Umbilicals

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Behavior of Flexible Pipe Subjected to Internal Pressure

Stress Response Behaviors of Steel Wires at the Anchorage Part of Bridge Cables under Tension and Bending Coupling Loads

Buckling Analysis of Plastic Pipe Reinforced by Cross-Winding Steel Wire under Bending

A Theoretical Method To Estimate The Fatigue Life Of Tensile Armors Of Flexible Pipes

Failure Analysis of Plastic Pipe Reinforced by Cross Helically Wound Steel Wire Subjected to Internal Pressure and Bending Load

An analytical approach for assessing the collapse strength of an unbonded flexible pipe

Analysis of the Mechanical Behaviors of Fiber Reinforced Unbonded Flexible Pipe Under Combined Load

Torsional Response Analysis of Flexible Pipe Based on Theory and Finite Element Method