Abstract:Steel structures with thick‐walled section tend to have local fracture before the occurrence of instability under strong earthquakes, which is termed as ultra‐low cycle fatigue (ULCF). In this study, a series of specimens made with structural steel Q345qC for bridge in China were firstly tested to investigate the ULCF fracture behaviour in material level. Based on the test data, three models for ULCF fracture were calibrated. Subsequently, the fracture behaviour of thick‐walled square section steel bridge piers were also investigated in component level. Moreover, the finite element global and submodels of steel bridge piers were established, and ULCF fracture initiation life was predicted by calibrated models and validated against test results. The research results showed that the crack firstly occurred at the bottom of piers under cyclic oblique loading, which was at the junction between base plate and bottom weld, and then, cracks propagated along the bottom weld metal which did not cause a decrease in strength capacity. Finally, the strength capacity of steel bridge piers began to rapidly declined as cracks propagated into base metal. The presented finite element global model can accurately simulate the cyclic behaviour of steel bridge piers, and the submodel has the ability of capturing the local stress and plastic strain. The fracture models accurately predicted ULCF fracture initiation life of steel bridge piers with the average discrepancy of 7.14%. The developed finite element analysis method considering ULCF fracture provides a solution for the further parametric analysis on ULCF fracture performance of steel bridge piers.

A Finite Element Model for Prediction of the Bending Stress of Umbilicals

Prediction of the Ultra-Low-Cycle Fatigue Damage of Q345qC Steel and Its Weld Joint

Study on Ultra‐low Cycle Fatigue Fracture of Thick‐walled Steel Bridge Piers

Analytical Prediction of Umbilical Behavior under Combined Tension and Internal Pressure

Theoretical and Finite-Element Study of Mechanical Behaviour of Central, Large-Diameter Umbilical Cables under Tension and Torsion

A Proposal on Ultra-Low Cycle Fatigue Damage Evaluation of Structural Steels

Analysis Of Subsea Umbilical Mechanical Behavior Under Simultaneous Bending, Tension And Torsion

Lateral buckling of umbilical cable armour under compression and bending

Prediction of nonlinear mechanical characteristics for metallic strip flexible pipe with bend stiffener constraints

Alternative analytical and finite element models for unbonded flexible pipes under axisymmetric loads

The Analysis of Mechanical Properties and Lightweight Design of Nonmetallic Armored Umbilical Cable

Flexible Riser Tensile Armour Stress Assessment in the Bend Stiffener Region

Buckling Response of Offshore Pipelines under Combined Tension and Bending

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Finite Element Analysis of Seamless Steel Tube NC Bending

Finite element analysis of birdcage buckling of umbilical cable with damaged sheath

Dynamic Analysis of Unbonded Flexible Pipe with Bend Stiffener Constraint and Bending Hysteretic Behavior

Mechanical analysis of finned special-shaped tubes in bending-torsional coupling deformation

Analysis of the bending performance of unbonded flexible risers

Finite element simulation prediction of repeated bending failure zone of roll-welded bellows based on an equivalent welding model