Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Lateral buckling of umbilical cable armour under compression and bending

Dynamic Analysis of the Umbilical Cable Pull-in Operation Through J-tube under Different Wave Directions

Finite element analysis of birdcage buckling of umbilical cable with damaged sheath

Theoretical and Finite-Element Study of Mechanical Behaviour of Central, Large-Diameter Umbilical Cables under Tension and Torsion

Analysis Of Subsea Umbilical Mechanical Behavior Under Simultaneous Bending, Tension And Torsion

The Analysis of Mechanical Properties and Lightweight Design of Nonmetallic Armored Umbilical Cable

Buckling Response of Offshore Pipelines under Combined Tension and Bending

Dynamic Analysis of Umbilical Cable under Interference with Riser

Stress Analysis Model for Un-Bonded Umbilical Cables

A Finite Element Model for Prediction of the Bending Stress of Umbilicals

Analytical Prediction of Umbilical Behavior under Combined Tension and Internal Pressure

Buckling Response of Offshore Pipelines under Combined Tension, Bending, and External Pressure

Global Responses of Exposed and Suspended Submarine Cables Due to Anchor Dragging

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

Study on contact force between umbilical and overboarding chute in deepwater S-lay process

Lateral Buckling of Subsea Pipelines Triggered by Combined Sleeper and Distributed Buoyancy Section

Motion modeling and simulation of umbilical cable during underwater vehicle’ s deployment

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Buckle Propagation Analysis of Deep-Water Petroleum Transmission Pipelines with Axial Tension

Dynamic Analysis of Umbilical Cable under Interference

Mechanical Behavior Analysis for Unbonded Umbilical under Axial Loads