Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Finite element analysis of birdcage buckling of umbilical cable with damaged sheath

Lateral buckling of umbilical cable armour under compression and bending

Cable Rupture Analysis of Inner-Outer Combined Reticulated Shell-String Structure Using VFIFE

Theoretical Analysis and Experimental Study on Sensitivity of Element-Length Error in Cable-Strut Tensile Structures

Failure analysis of suspen-dome by vector form intrinsic finite element method

Sensitivity analysis on responses of adaptive cable-strut tensile structure with length changeable elements

Theoretical and Finite-Element Study of Mechanical Behaviour of Central, Large-Diameter Umbilical Cables under Tension and Torsion

Finite element analysis and experimental research on cable domes

Stress Analysis Model for Un-Bonded Umbilical Cables

Study on static behaviour of cable domes

A Finite Element Model for Prediction of the Bending Stress of Umbilicals

Analysis Of Subsea Umbilical Mechanical Behavior Under Simultaneous Bending, Tension And Torsion

The Analysis of Mechanical Properties and Lightweight Design of Nonmetallic Armored Umbilical Cable

Global Responses of Exposed and Suspended Submarine Cables Due to Anchor Dragging

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

Mechanical Behavior Analysis for Unbonded Umbilical under Axial Loads

Dynamic Analysis of Umbilical Cable under Interference with Riser

Fatigue Damage Study of Helical Wires in Catenary Unbonded Flexible Riser Near Touchdown Point

Reliability analysis of carbon fiber rod-reinforced umbilical cable under tension using an improved sampling method

Buckling Response of Offshore Pipelines under Combined Tension and Bending

Bending Study of Submarine Power Cables Based on a Repeated Unit Cell Model