Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Failure Characteristic Analysis of Tensile Armour Layer of Unbonded Flexible Riser under Axial Compression

Numerical Simulation of Burst Failure in 2.5-Inch Unbonded Flexible Riser Pressure Armor Layers

Nonlinear Slippage of Tensile Armor Layers of Unbonded Flexible Riser Subjected to Irregular Loads

Axial Tensile Ultimate Strength of an Unbonded Flexible Riser Based on a Numerical Method

Adiabatic Shear Fractures and Fragments of Cylindrical Structures under Internal Explosive Loading

Micromechanics-based Progressive Failure Analysis of Carbon FIber/epoxy Composite Vessel under Combined Internal Pressure and Thermomechanical Loading

Cross-sectional mechanical characteristics and sensitivity analysis of unbonded flexible risers under axial loads

Flexible Riser Tensile Armour Stress Assessment in the Bend Stiffener Region

Buckle Propagation Analysis of Deep-Water Petroleum Transmission Pipelines with Axial Tension

Quasi-static Axial Crushing and Transverse Bending of Double Hat Shaped CFRP Tubes

Mechanical Analysis of Flexible Riser with Carbon Fiber Composite Tension Armor

Analysis of the bending performance of unbonded flexible risers

Torsional Response Analysis of Flexible Pipe Based on Theory and Finite Element Method

Finite Element Analysis of Adhesive Failure of Solid Composite Propellant Multi-material Structure for Underwater Intelligent Equipment

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

A Theoretical Method To Estimate The Fatigue Life Of Tensile Armors Of Flexible Pipes

Alternative analytical and finite element models for unbonded flexible pipes under axisymmetric loads

Analysis of the Mechanical Behaviors of Fiber Reinforced Unbonded Flexible Pipe Under Combined Load

Anisotropic failure analysis of 2.5-D braided composites under compression

Mechanical Characteristics of Fiber-Reinforced Flexible Pipe Subjected to Axial Tensile Load

Modeling and Optimization of Ultra High Pressure Vessel with Self-Protective Flat Steel Ribbons Wound and Tooth-Locked Quick-Actuating End Closure