Abstract:Internet of Things applications, including medical diagnostics, imaging and industrial process controls, pollution monitoring or real-time motion control, push the extension of the Si photonics towards mid-infrared range. In recent years, group IV SiGeSn-based optoelectronic devices including light emitting, detectors, modulators, and CMOS devices have been developed. The main advantage of SiGeSn is the bandgap tunability in the range between 1.5 to 5 μm via Si and Sn compositions. Remarkably, the GeSn binary alloy becomes a direct bandgap semiconductor at a relative low Sn content of about 7-8 at.% opening the quest for the realization of monolithically integrated laser sources on Si. In this direction, from the first laser emission proof in 2015 remarkable progress has been done. Supported by epitaxial growth success, processing technology, and cavity design, the laser emission of optically pumped was continuously increased from 80K to 270K. The main role here was played by increasing the Sn content up a concentration of 17 at.%. The next major improvement came from layer transfer technology allowing defect engineering and heat management. Their combination made possible room temperature lasing. However, the real life application requires low laser threshold. Here the use of multiple quantum wells based on SiGeSn/GeSn heterostructures and strain engineering allow a remarkable threshold reduction to values of about 1 kA/cm 2 . Interestingly, modeling shows that the very epitaxial challenging of having high Sn contents can be reduced by band structure engineering via introducing tensile strain and, in addition, larger gains are possible compared with high-Sn strain free layers. The optical laser spectrum at 0 °C for a GeSn layer under 1 % biaxial tensile strain is shown in Fig 1a. The next step is the realization of an electrical pumped GeSn laser. The first data indicate that both waveguide and microdisk cavities can be electrically pumped leading to low temperature laser emission. The effect of the geometry and strain relaxation of under-etched cavities on the laser emission is under study. Figure 1b shows an exemplary spectrum and current-in light-out (LI) curve for a device with a SiGeSn/GeSn heterostructure taken at 50 K. Figure 1

Si-Based Mid-Infrared GeSn-Edge-Emitting Laser with Operating Temperature Up to 260 K

Electrically Injected mid-infrared GeSn laser on Si operating at 140 K

Optically Pumped Si-based Edge-Emitting GeSn Laser

Gesn Alloys: From Optical to Electrical Pumped Lasers

Mid-infrared silicon photonic lasers based on GeSn slab waveguide on silicon

Grafted AlGaAs/GeSn Optical Pumping Laser Operating up to 130 K

Design of Tensile-Strained GeSn/SiGeSn Structure for Low Threshold Mid-infrared Laser Application

Room Temperature Lasing in GeSn Microdisks Enabled by Strain Engineering

Ultra-low threshold cw and pulsed lasing in tensile strained GeSn alloys

1D photonic crystal direct bandgap GeSn-on-insulator laser

GeSn-based Light Sources and Photoconductors Towards Integrated Photonics for the Mid-Infrared

Strained GeSn laser with multiple fins structure based on SiN stress

Reduced lasing thresholds in GeSn microdisk cavities with defect management of the optically active region

Recent Progress in GeSn Growth and GeSn-based Photonic Devices

Simulation and optimization of strained GeSn laser with SiN-induced stress

Continuous-wave GeSn light emitting diodes on silicon with $2.5 \, μ$m room-temperature emission

GeSn/SiGeSn Photonic Devices for Mid-Infrared Applications: Experiments and Calculations

Investigation of SiGeSn/GeSn/SiGeSn Quantum Well Structures and Optically Pumped Lasers on Si

Development of SiGeSn Technique Towards Integrated Mid-Infrared Photonics Applications

Design of a Si-based Lattice-matched GeSn/SiGeSn Multi-quantum-well Laser

Iv-Vi Semiconductor Growth on Silicon Substrates and New Mid-Infrared Laser Fabrication Methods