High‐temperature Multilayer Actuators Based on CuO Added BiScO3–PbTiO3 Piezoceramics and Ag Electrodes

Muhammad Adnan Qaiser,Xiao-Zi Ma,Rongtian Ma,Wajid Ali,Xijun Xu,Guoliang Yuan,Lang Chen
DOI: https://doi.org/10.1111/jace.16435
IF: 4.186
2019-01-01
Journal of the American Ceramic Society
Abstract:High-temperature multilayer actuators based on Cu doping 0.367BiScO(3)-0.633PbTiO(3) ceramic slices and Ag electrodes were prepared by low-temperature co-firing technology. The 0.3 wt% CuO addition has effectively reduced the sintering temperature of the ceramic from similar to 1080 to 930 degrees C, thus the multilayer actuator were sintered at 930 degrees C which is lower than the Ag melting point, that is, 961 degrees C. The 4.3mm thick multilayer actuator is composed of a series of similar to 44-mu m-thick ceramic slices and similar to 2-mu m-thick Ag electrodes. As a result, a >= 0.13% strain with nm-scale preciseness can be produced in the actuator by 200V driving voltage not only at room temperature but also at a high temperature up to 200 degrees C. This actuator is essential for industrial machinery that requires nm-scale position control at 20-200 degrees C.
What problem does this paper attempt to address?