Abstract:To purify and recycle the low-carbon alcohols and acids in wastewater by a green method with high efficiency is of great significance in chemical engineering process, such as indirect coal liquefaction (Fischer Tropsch Synthesis, FTS), which produces a large amount of alcohol and acid-containing wastewater. Adsorption-desorption of low-carbon alcohols and acids in wastewater by activated carbon is a promising method for industrial application. The adsorption capacity of low-carbon alcohols and acids in activated carbons is closely related with their pore and surface properties. However, this was seldom studied due to the complex properties of carbon materials with different pore size, distribution and volume, as well as surface area and hydrophobicity. In this work, four commercial activated carbon materials (AC1 ∼ 4) with similar hydrophobicity and different pore and surface structure were chosen to explore the possible correlation of the adsorption capacity of C1-5 alcohols, C2-4 acids and FTS modeling wastewater. The batch method was used to investigate the adsorption capacity of AC1 ∼ 4 on low-carbon alcohols and acids as well as FTS modeling wastewater; while density functional theory (DFT) calculation was performed to investigate the adsorption energies of low-carbon alcohols and acids in carbon nanotubes with different pore sizes. Both the experimental and theoretical results indicate that the adsorption capacities of methanol, ethanol and acetic acid are strongly dependent on the ultra-micropores (<0.9 nm) due to their small molecular weight; and the adsorption capacity of pentanol is mainly determined by the surface areas due to its relatively high molecular weight and low polarity; while the adsorption capacities of C3-C4 alcohols and acids are well correlated with the microporous volume and surface area. In addition, and the adsorption capacities of acids were also related with the content of surface COOH species. AC2 has the highest adsorption capacity of mixed low-carbon alcohols and acids (196.2 mg/g) in FTS modeling wastewater due to its abundant ultra-micropore and high specific surface area. This work sheds light into the development of adsorbents with high adsorption capacity of low-carbon alcohols and acids, and provides solid experimental and theoretical support in the further purification of FTS wastewater and recovery of valuable chemicals.

Experimental study of ethanol adsorption using a multistage bubbling fluidized bed

Simulation of Levulinic Acid Adsorption in Packed Beds Using Parallel Pore/Surface Diffusion Model

Stability of expanded beds during the application of crude feedstock.

The influence of biomass on the hydrodynamic behavior and stability of expanded beds.

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Removal of VOCs using sludge-based adsorbents

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Study of adsorption performance of vertical radial flow dual-bed adsorber used in air sparation unit

Preparation and characteristics of a novel packing material for VOC gas-phase fluidized-bed bioreactor

A complementary VOCs recovery system based on cryogenic condensation and low-temperature adsorption

Probing the differences in CO 2 adsorption/desorption behaviors of solid amine sorbents in fixed and fluidized beds

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Investigation of the competitive adsorption mechanism between typical volatile organic compounds (VOCs) and water vapor in waste gas emissions from the fermentation industry

Numerical Simulations of CO2 Absorption by MgO-based Sorbent in a Gas–solid Fluidized Bed

The effect of relative humidity on multicomponent organic vapor adsorption on composite beds with micro-fibrous entrapped activated carbon

Exploration of the adsorption and desorption performance of volatile organic compounds by activated carbon with different shapes based on fixed-bed experiments

Adsorption characteristics of water vapor on the hypercrosslinked polymeric adsorbent

Experimental and theoretical study of the adsorption of mixed low carbon alcohols and acids from Fischer Tropsch synthesis wastewater by activated carbon

Reconfiguring closed-loop desorption for industrial solvent recycling by retaining post-condensation volatile organic compounds

Prediction of the breakthrough curves of VOC isothermal adsorption on hypercrosslinked polymeric adsorbents in a fixed bed

Ionic-Liquid-Assisted Capture of Volatile Low-Carbon Alcohols in Printing Plant Exhaust Gas