Abstract:The high-temperature tensile deformation behaviors of the recrystallization annealed Al7(CoNiV)93 medium entropy alloy with a duplex hierarchical microstructure of face-centered cubic (fcc) and ordered body-centered cubic L21 Heusler-type grains were investigated. The alloy showed a remarkably high tensile strength of ∼1.1 GPa and good ductility of ∼17% at 923 K due to a good strain hardening capacity of 60 MPa. At 1073 K, the highest fracture elongation of ∼270% was displayed at a strain rate of 10−3 s−1. The strain rate sensitivity was estimated to be about 0.32, which is typical of alloys that show this quasi-superplastic elongation. The activation energy was also estimated to be ∼421 kJ/mol. With deformation at 1073 K at a strain rate of 10−3 s−1, the duplex microstructure transformed into a refined triplex fcc-L21-σ equiaxed microstructure. The development of the triplex equiaxed microstructure resulted from dynamic recrystallization (DRX), which assisted in the maximum superplastic-like elongation of 270%. The inability of the alloy to access true superplasticity was attributed to immense cavitation due to the high amount of the brittle σ phase, which served as de-cohesion sites for the early fracture of the sample. However, the observed quasi-superplasticity could still be useful in superplastic forming operations.

A Promising CoFeNi2V0.5Mo0.2 High Entropy Alloy with Exceptional Ductility

Preparation and properties of FeNiMnCuC0.2Alx high-entropy alloy

Inherent and Multiple Strain Hardening Imparting Synergistic Ultrahigh Strength and Ductility in a Low Stacking Faulted Heterogeneous High-Entropy Alloy

A novel, single phase, non-equiatomic FeMnNiCoCr high-entropy alloy with exceptional phase stability and tensile ductility

Excellent strength-ductility synergy in a novel single-phase equiatomic CoFeNiTiV high entropy alloy

The cobalt-free Fe35Mn15Cr15Ni25Al10 high-entropy alloy with multiscale particles for excellent strength-ductility synergy

Design of novel AlCoFeNiV high-entropy alloys with high-strength and high-ductility

A novel Fe-Co-Ni-Si high entropy alloy with high yield strength, saturated magnetization and Curie temperature

Unraveling the Deformation Behavior of the Fe45Co25Ni10V20 High Entropy Alloy

Quasi-superplasticity in the AlCoNiV Medium Entropy Alloy with Heusler L21 Precipitates

Abnormal strain-hardening in Co-rich CoNiV medium-entropy alloys

Co-free non-equilibrium medium-entropy alloy with outstanding tensile properties

Strong and ductile CrCoNi medium-entropy alloy via dispersed heterostructure

Microstructural features and excellent compression properties of a novel Al0.7CoCrFeNiTi0.3 high entropy alloy

Influence of V and Al in Enhancing the Strength and Ductility of Co-rich High-Entropy Alloys

Tensile Properties of a Non-Equiatomic Ni–Co–V Medium Entropy Alloy at Cryogenic Temperature

B2-strengthened Al-Co-Cr-Fe-Ni high entropy alloy with high ductility

Microstructures and mechanical properties of FeCoNi(MoW) high-entropy alloys

Exceptional high-strain-rate tensile mechanical properties in a CrCoNi medium-entropy alloy

A dual-phase alloy with ultrahigh strength-ductility synergy over a wide temperature range

Lamellar-structured low-cost FeMn0.7Ni0.6Cr0.4Al0.3 high entropy alloy with excellent tensile properties