Abstract:In this work, a Fe-rich nonequiatomic Fe40Cr15Co15Mn10Ni20 high-entropy alloy was successfully prepared based on phase analysis and cost reduction. Fe40Cr15Co15Mn10Ni20 high-entropy alloy with a single-phase face-centered cubic (FCC) structure was strengthened by the addition of 11 at.% Al or 10 at.% Mo, and the variations of phase and mechanical properties of the strengthened alloys were subsequently investigated. It has been found that the addition of 11 at.% Al led to the formation of FCC and body-centered cubic (BCC) dual-phase structure in the Fe40Cr15Co10Mn4Ni20Al11 alloy, while its yield strength (σ0.2) and tensile strength increased from 158 ± 4 MPa and 420 ± 20 MPa to 218 ± 7 MPa and 507 ± 16 MPa, respectively, as compared to the single-phase FCC structure Fe40Cr15Co15Mn10Ni20 alloy. The addition of 10 at.% Mo introduced intermetallic compounds of μ and σ phases, which resulted in improved yield strength of 246 ± 15 MPa for the Fe40Cr15Co10Mn5Ni20Mo10 alloy. However, the alloy exhibited premature brittle fracture due to the existence of a large number of intermetallic compounds, which led to deteriorated tensile strength of 346 ± 15 MPa. The findings of this work suggest that the introduced secondary phases by the addition of Al and Mo can effectively strengthen the high-entropy alloy; however, the number of intermetallic compounds should be controlled to achieve a combination of high strength and good ductility, which provides a reference for the follow-up study of nonequiatomic high-entropy alloys.

Microstructures and mechanical properties of FeCoNi(MoW) high-entropy alloys

Preparation and properties of FeNiMnCuC0.2Alx high-entropy alloy

Microstructure and mechanical properties of CoCrFeNiW high entropy alloys reinforced by μ phase particles

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

Microstructural Evolution and Mechanical Properties of Al0.3CoCrFeNiSix. High-Entropy Alloys Containing Coherent Nanometer-Scaled Precipitates

Effect of Mo Content on Microstructure and Mechanical Properties of CoCrFeNi Series High-entropy Alloys

Microstructure and compression properties of a dual-phase FeCoCrMn high-entropy alloy

Microstructure Evolution and Strengthening Mechanism of AlCrFe2NiCuMox High Entropy Alloys

Effects of Al or Mo Addition on Microstructure and Mechanical Properties of Fe-Rich Nonequiatomic FeCrCoMnNi High-Entropy Alloy

Alloying behavior of W and Mo in the as-cast dual-phase FeNiCrAl multi-component alloys

Effects of Mo on microstructure and mechanical properties of Fe2Ni2CrMox eutectic high entropy alloys

Microstructure and mechanical properties variation with Ni content in Al0.8CoCr0.6Fe0.7Nix (x = 1.1, 1.5, 1.8, 2.0) eutectic high-entropy alloy system

Study on strength and toughness of FeCoCrNiAlx high entropy alloy

Mechanical properties and fracture mechanism of as-cast MnFeCoCuNi high-entropy alloys

Multiscale-phase-driven strength-ductility synergy in Fe3Cr2CoNiAlx high entropy alloys

Microstructure Evolution and Mechanical Properties of Ultra-Fine Grain AlCrFe2Ni2Wx High-Entropy Alloys

Microstructure evolution and mechanical properties of CoCrFeNiAl0.3 high entropy alloy produced by ball milling in combination with thermomechanical consolidation

Effect of Alloying on Microstructure and Mechanical Properties of AlCoCrFeNi2.1 Eutectic High-Entropy Alloy

Microstructure and Mechanical Properties of New AlCo<sub>x</sub>CrFeMo<sub>0.5</sub>Ni High-Entropy Alloys

Phase evolution and mechanical properties of novel FeCoNiCuMox high entropy alloys

Mechanical and tribological properties of (FeCoNi)88-x(AlTi)12Mox high-entropy alloys