Abstract:The thermophysical properties of dense ZrB2-20 vol% SiC ceramics (ZS) with and without doping of 5 vol % WC (ZSW) were characterized up to 1800 degrees C. Because of the in-situ formed WB with low thermal conductivity and the strong phonon scattering effect from (Zr,W)B-2 solid solution, the thermal conductivity of ZSW (36.2 W/(m K)) at room temperature is much lower than that of ZS (100.4 W/(m K)), however, their differences at 1800 degrees C is very limited (42.2 W/(m K) for ZSW and 47.4 W/(m . K) for ZS). The detailed calculation indicates that contributions from lattice vibrations on the thermal conductivity decreased to nearly zero at 1800 degrees C in both samples, therefore, electrical conductivity of ZS and ZSW dominates their thermal transport behavior at higher temperatures. Furthermore, amorphous phase with compositions of Ca-Al-Si-O was occasionally found at the triple junction of ZS, its softening and rewetting of the grain boundary at higher temperature were confirmed from the internal friction curve and microstructural characterization at different levels, which was thought to be responsible for the tremendous increase of Interfacial thermal resistance and continuous drop of thermal conductivity of ZS up to 1800 degrees C. On the contrary, benefiting from the clean boundary and tight triple junction in ZSW, its thermal conductivity can stabilize between 36 and 47 W/(m K) in a broad temperature range from 25 to 1800 degrees C. Based on the measurement above, the type of carriers and thermoelectric figure of merit (zT) in ZrB2-SiC based ceramics are also firstly reported. (C) 2017 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Strong ZrC Ceramics at High Temperatures with the Addition of W

Dense Submicron-Sized ZrC – W Composite Produced by Reactive Melt in Fi Ltration at 1200 ° C

Influence of Zrc Content on the Elevated Temperature Tensile Properties of Zrcp/W Composites

High-temperature deformation of ZrB2 ceramics with WC additive in four-point bending

Extraordinary High-Temperature Mechanical Properties in Binder-Free Nanopolycrystalline WC Ceramic

Thermal and Electrical Transport in ZrB2-SiC-WC Ceramics Up to 1800 °C

Enhanced high‐temperature strength in textured (Ti1/3Zr1/3Hf1/3)B2 medium‐entropy ceramics via strong magnetic field

Effect of ZrC nano-powder addition on the microstructure and mechanical properties of binderless tungsten carbide fabricated by spark plasma sintering

Mechanical properties of ZrB2/SiC/WC ceramic tool materials from room temperature to 1100 °C and cutting performance

Chemical Process and Solid Solution Formation in Reactive Hot Pressed ZrB2–SiC Ceramics Doped with W

Ultra-coarse cemented tungsten carbide with (Zr,W)C x precipitates in ceramic phase

Spark plasma sintered WC-Ni cemented carbides with various contents of ZrC nano-powder

Mechanical Properties of ZrB<sub>2</sub>-Based Ceramics Reinforced by Nano-SiC Whiskers

In Situ ZrB2 Formation in B4C Ceramics and Its Strengthening Mechanism on Mechanical Properties

Improved comprehensive mechanical properties of oscillatory pressure sintered WC–ZrO2–Al2O3 ceramics with VC/Cr3C2 addition

Novel low temperature derived W f /W-ZrC-Cu composites by reactive infiltration with enhanced mechanical and thermal physical properties

Novel (Zr, Ti)(C, N)–SiC ceramics via reactive hot-pressing at low temperature

Seed-mediated growth of ZrC whisker and its toughening effect on ZrB2-SiC-C ceramic

Enhanced Oxidation Resistance of ZrB2‐SiC‐WC Composite Below 1800 °C

Novel TiC-based ceramic with enhanced mechanical properties by reaction hot-pressing at low temperature

Preparation and properties of zirconium diboride-based ultra-high temperature ceramics