Abstract:This paper strives to derive the analytical solutions for the dynamic analysis of stepped multi-span rotor system, where the rotating shaft's internal damping effect is also considered. Specifically, the steady-state whirl analysis and free vibration analysis is given herein. For the steady-state whirl analysis, firstly, the stepped shaft is spilt to several uniform segments and their governing equations are established by Hamilton principle. Subsequently, by applying variable separation method and Laplace transform method to each segment's governing equation, their steady-state responses in terms of determinate interpolation functions multiplied by unknown boundary constants are derived. Then based on the transfer matrix method, each segment's boundary constants are determined with consideration of the compatibility conditions of each two adjacent segments and the end boundary conditions. For the free vibration analysis, one only need to remove the forced term in the steady-state form of transfer matrix and the rotor's characteristic equation will be obtained. Through the theoretical derivation, it is found that this analytical approach can be generalized to any isotropic elastic boundary conditions. To validate the proposed method, two case studies are proposed, where the finite element method is used as benchmark method. For the first one, the influence of internal damping on a uniform rotor's damped whirl characteristics and its stability is analyzed. The damped whirl characteristics analysis reveals that viscous internal damping result in the destabilization of forward modes as long as the spinning speed becomes higher than the critical speed. This phenomenon is also demonstrated by the time responses analysis. For the second one, the dynamic responses of a two-span three steps rotor-bearing system with isotropic viscoelastic boundary conditions are determined. All of simulated results show a great agreement between analytical results and FEM results.

Stability Analysis of a Flexible Rotor Partially Filled with Two Liquid Phases

Stability Analysis of Symmetrical Rotors Partially Filled with a Viscous Incompressible Fluid

Experimental Study on Vibration and Stability of an Over-Hung Flexible Rotor Partially Filled with Two Kinds of Fluids

Stability of a Rotor System on Support of Anisotropical Rigidity and Partially Filled with an Inviscid Fluid

Experimental Investigation into the Effect of Fluid Viscosity on Instability of an Over-Hung Flexible Rotor Partially Filled with Fluid

Instability of an Over-Hung Rigid Centrifuge Rotor Partially Filled with Fluid

Stability Behaviour Of An Isotropic Rotor System Anisotropically Mounted And Partially Filled With Inviscous Fluid

DYNAMIC BEHAVIOUR OF A ROTOR PARTIALLY FILLED WITH FLUID IN THE UNSTABLE REGION

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Effect of fluid viscosity on stability of a flexible rotor partially filled with fluid

Stability of the Flapping-Wing Vehicle Near Hovering under Active Control by Varying Flapping Frequency

Lubrication and stability analysis of nonlinear rotor-bearing system

Whirl dynamics of an axially functionally graded liquid-filled rotor considering shear deformation and rotary inertia

Stability analysis of a rotor system with electromechanically coupled boundary conditions under periodic axial load

Stability of equilibrium of the body with filling

Stability of Active Magnetic Bearing Flexible Rotor System under Base Swing Condition

Study on the dynamics, relative equilibria, and stability for liquid-filled spacecraft with flexible appendage

Nonlinear Analysis of Stability and Rotational Accuracy of an Unbalanced Rotor Supported by Aerostatic Journal Bearings

Fluid–structure stability analyses and nonlinear dynamics of flexible splitter plates interacting with a circular cylinder flow

Nonlinear Dynamic Analysis of a Rigid Rotor Supported By a Spiral-Grooved Opposed-Hemisphere Gas Bearing

Analytical approach to the stepped multi-span rotor-bearing system with isotropic elastic boundary conditions