Influences of Co and process parameters on structure and corrosion properties of nanocrystalline Ni-W-Co ternary alloy film fabricated by electrodeposition at low current density
Weiwei Zhang,Wenzhe Xia,Baosong Li,Mingyuan Li,Ming Hong,Zhen Zhang
DOI: https://doi.org/10.1016/j.surfcoat.2022.128457
IF: 4.865
2022-04-01
Surface and Coatings Technology
Abstract:In this paper, efforts have been dedicated to electrodeposit nanocrystalline Ni-W-Co ternary alloy film on copper substrate through electrodeposition in sulfate-citrate bath. Effects of electrodeposition parameters such as Co ion concentration, applied current density, electrolytic bath pH and deposition time on structural, composition, surface characteristics and corrosion properties of Ni-W-Co alloys were explored. Corrosion and wear behaviors were evaluated. It proved that Ni-W-Co alloy has a uniform, compact and flatter surface, exhibiting colony-like morphology. Amorphous or nanocrystalline structure was formed depending on the process parameters including current density, pH and electrolyte composition. The crystallite size was little affected by Co content but greatly affected by current, bath pH and the duration of plating time. The average roughness Ra was optimized to 4–7 nm. This ternary alloy contains 33 wt% W, 21–60 wt% Ni and 2.8–40 wt% Co. In the alloy, the decrease of nickel content corresponds to the increase of Co and vice versa. W content varied little with the change of electrodeposition conditions. Co content slightly decreases as current density increases. Increasing bath pH greatly decreases the Co contents and increases the Ni content. A ternary complex [M(HWO4)(C6H5O7)]2−(M = Ni, Co) in solution is crucial for the formation of Ni-W-Co alloy. The optimized process parameters for best corrosion and wear resistance were 5–8 mA cm−2, 55 min, 0.1 mol L−1 Co2+ and pH = 6.
physics, applied,materials science, coatings & films