Abstract:The software-assisted reliability assessment of power electronic converters is increasingly important due to its multi-domain nature and extensive parametric calculations. The rainflow counting algorithm is gaining popularity for its low relative error in device lifetime estimation. Nevertheless, the offline operation of the algorithm prevents most simulation software packages considering other parameters for the device under study, such as aging and the current state of health in the estimation, as it requires a complete loading profile to run recursive comparison. This also brings difficulties in realization in circuit simulators such as SPICE. To tackle the issue, an in-the-loop circuit-based rainflow counting algorithm is proposed in this paper, and applied to estimate the consumed lifetime of the MOSFET in a boost converter for illustration. Instantaneous electrical and thermal performances, and the accumulated stress of the device can be monitored. Not only does this assist in evaluating the state of health of a device, but also allows the possibility of integrating the aging into the lifetime evaluation. The method follows the four-point rainflow counting algorithms, which continuously compares three adjacent temperature fluctuations ΔTj to select full cycles for two rounds, and the remaining cycles are counted as half cycles. To validate the performance, a comparative analysis in terms of counting accuracy and simulation speed was performed alongside the proposed method, MATLAB® and also with a well-accepted half-cycle counting method. Reported results show that the proposed method has an improved counting accuracy compared to the half-cycle counting from 24% to 3.5% on average under different load stresses and length conditions. The accuracy can be effectively improved by a further 1.3–2% by adding an extra comparison round.

A Dynamic Time Evolution Method for Concurrent Device-Circuit Aging Simulations

Concurrent device/circuit aging for general reliability simulations

Compact Modeling and Simulation of Accelerated Circuit Aging

A Device-Circuit Aging Simulation Framework Integrating Trap-Based Models and Sensitivity Analysis for FinFET Technology

Aging-Aware Gate-Level Modeling for Circuit Reliability Analysis

Wear-out Evolution Analysis of Multiple-Bond-wires Power Modules Based on Thermo-Electro-mechanical FEM Simulation

Parallel Multiphysics Simulation for Characterizing Performance Degradation of RF Components

Sensor-Driven Reliability and Wearout Management

Towards Reliability-Aware Circuit Design in Nanoscale FinFET Technology: — New-generation Aging Model and Circuit Reliability Simulator

Modeling and Predicting Transistor Aging under Workload Dependency using Machine Learning

Efficient Aging-Aware Standard Cell Library Characterization Based on Sensitivity Analysis

Statistical Reliability Analysis under Process Variation and Aging Effects

Circuit-Based Rainflow Counting Algorithm in Application of Power Device Lifetime Estimation

Accelerated Aging in Analog and Digital Circuits with Feedback

Novel Critical Gate-Based Circuit Path-Level NBTI-Aware Aging Circuit Degradation Prediction.

A Fast Aging-aware Static Timing Analysis Prediction Frame of Digital Integrated Circuits

A Pragmatic Model to Predict Future Device Aging

System-level variation-aware aging simulator using a unified novel gate-delay model for bias temperature instability, hot carrier injection, and gate oxide breakdown

Characterization and Modeling of Hot Carrier Degradation Under Dynamic Operation Voltage

Investigation of the Off-State Degradation in Advanced FinFET Technology—Part II: Compact Aging Model and Impact on Circuits

Layout-dependent aging mitigation for critical path timing.