Abstract:Flashover voltage of contaminated insulators relates to the damp degree of pollution layer on the insulators.Humidity and temperature-difference are two typical factors for dirty layer wetting.We introduced the roles of temperature and humidity in about one-hour short-term wetting of contamination layer.A series of artificial pollution trials,including temperature difference trials and humidity trials,were designed in a temperature and humidity controllable fog chamber.A solid layer method was adopted in the artificial pollution tests,during which ceramic suspension insulators XP-70 were contaminated by brushing specified quantity pollution.Experimental results suggest that when relative humidity(RH) does not reach to 100% and RH as the only factor for wetting,wetting process of dirty layer is very slow and one-hour is not enough to fully damp dirty,thus the NaCl in the contamination cannot be dissolved absolutely and the contribution of NaCl to the conductivity of surface pollution is limited.When the RH reaches to 100% with no temperature difference,contamination can be immediately wetted.Researches also show that temperature difference plays an important role during short-term wetting process.The difference between insulators temperature and the dew point of environment directly affects the strength of leakage current.Temperature difference only in the initial period of wetting plays a dominate role.With the disappearing of temperature difference,humidity becomes the leading factor for dirty damp.The maintenance time of temperature difference playing a leading role in wetting is related to the radiating area and specific heat capacity of the test sample.The smaller the specific is,or the larger the radiating area is,the shorter time the temperature-difference works.

Research on Wetting Characteristics of Insulator in Ultrasonic Fog

Measurement of Saturated Water Absorption of the Contamination Layer Deposited on Insulator Surface

Feasibility Research of Defect Testing for Basin Insulator Based on Ultrasonic Guided Wave

Experimental Study on the Contamination Deposition Characteristics of Insulators in a Fog–haze Environment

Research on Pollution Accumulation Characteristics of Insulators During Fog-Haze Days

Influence of Temperature Difference on Wetting Characteristics of Insulators

Wetting Characteristics of the Hydrophobic Material Surface Through Condensation

Leakage current analysis on RTV coated porcelain insulators during long term fog experiments

Analysis On Flashover Performance Of Polluted Porcelain Insulators In High Conductivity Fog Environment

Temporal and spatial characteristics of soluble salt components accreted on the insulator surface

Wetting Characteristics of Artificial Contamination on the Hydrophobic Surface

Effective Equivalent Salt Deposit Density of Polluted Silicone Rubber Insulators in Wetting Process

Performance of Insulators Treated with Semiconductive Silicone Rubber Coating During Fog and Polluted Conditions

Flashover Characteristics of Post Insulators Under Fog and Haze Conditions

Roles of Humidity and Temperature Difference in Pollution Layer Wetting of Insulators

A Low-Cost Evaluation and Correction Method for the Soluble Salt Components of the Insulator Contamination Layer

Experimental Study on the Pollution Flashover Mechanism of Polymer Insulators

Discharge Behavior and Morphological Characteristics of Suspended Water-Drop on Shed Edge during Rain Flashover of Polluted Large-Diameter Post Insulator

Effects of Natural Contamination Components on the Surface Conductivity under Saturated Moisture

Mechanism of contaminant accumulation and flashover of insulator in heavily polluted coastal area

Insulator Contamination Monitoring Based on Its Hygroscopicity Under Unsaturated Humidity