Abstract:In this research, the thermomechanical fatigue (TMF) characteristics of a second-generation Ni-based single-crystal superalloy were investigated. The combined effects of temperature cycling and mechanical stress were examined using a strain-controlled approach under different TMF testing conditions. The results indicated that cyclic softening occurred during the early stages during in-phase (IP) loading. In contrast, out-of-phase (OP) tests exhibited cyclic hardening, as evidenced by an increase in the stress range, which intensified at higher mechanical strain amplitudes. This resulted in a shorter fatigue life compared to the IP TMF case. The crack distribution patterns and damage mechanisms on the cross-sectional and fracture surfaces of the failed specimens were analyzed. In the OP TMF tests, oxidation-assisted cracking was identified as the primary damage mechanism. The dominance of oxide layers was a key distinguishing feature. Additionally, twinning-related deformation and topologically close-packed (TCP) phase particles were observed in specimens subjected to a higher mechanical strain of 0.6%, where they ran parallel to the main crack, contributing to a reduction in lifetime. Conversely, the IP TMF cases were mainly dominated by creep damage mechanisms, with some signs of oxidation penetration observed during testing. The application of the Ostergren model to the fatigue life prediction of a Ni-based single-crystal superalloy under both conditions was evaluated. As this model was insufficient, a modified Ostergren model was proposed by incorporating the maximum and amplitude stresses in the power law forms.

Life Assessment of Multiaxial Thermomechanical Fatigue of a Nickel-Based Superalloy Inconel 718

Investigation of fatigue mesoscopic mechanical properties of a nickel-based superalloy by instrumented microindentation measurements

A Study of Fatigue Mesoscopic Elasto-Plastic Properties of a Nickel-Base Superalloy by Instrumented Microindentation Measurements

Cyclic Plasticity Modeling of Nickel-Based Superalloy Inconel 718 under Multi-Axial Thermo-Mechanical Fatigue Loading Conditions

Thermal Gradient Mechanical Fatigue Assessment of a Nickel-Based Superalloy

Multi-axial Fatigue Life Assessment of Additively Manufactured Nickel-Based Superalloys

Assessment of Thermo-Mechanical Fatigue in a Nickel-Based Single-Crystal Superalloy CMSX-4 Accounting for Temperature Gradient Effects

Effects of creep and oxidation to thermomechanical fatigue life assessment for nickel-based superalloy

Thermodynamic Entropy-Based Fatigue Life Assessment Method for Nickel-Based Superalloy GH4169 at Elevated Temperature Considering Cyclic Viscoplasticity

Multiaxial Fatigue Life Prediction Based on Nonlinear Continuum Damage Mechanics and Critical Plane Method

Life Assessment of Anisotropic Low Cycle Fatigue of Nickel-Base Single Crystal Superalloy

The low-cycle fatigue behavior and an entropy-based life prediction model for Nickel-based single crystal superalloy across an extensive temperature range

Thermal-mechanical fatigue life prediction considering fatigue-creep interaction effects

Investigation of damage mechanisms in thermomechanical fatigue of nickel-based single-crystal alloys

A Model for the Determination of Residual Fatigue Life of A Nickel-Based Superalloy

A critical-plane-based thermomechanical fatigue lifetime prediction model and its application in nickel-based single-crystal turbine blades

A novel very-high-cycle-fatigue life prediction model with interior microstructure induced cracking behavior of Inconel-713C superalloy at 25 °C, 750 °C and 1000 °C

Fatigue and Fracture Behavior of Nickel-Based Superalloy Inconel 718 Up to the Very High Cycle Regime

Comparison of fatigue characteristics and failure analysis of Ni-based superalloy subjected to thermomechanical fatigue under different phase conditions

Thermomechanical Fatigue of Nickel-Based Single-Crystal Superalloys

The mean stress and phase angle effect on multiaxial fatigue behavior of a TiAl alloy: Failure analysis and life modeling