Abstract:Metallurgical-grade silicon-refined waste slag (MGSRS) was produced during the MG-Si refining production process, which occupies huge amounts of land resources, caused the loss of nearly 110,000 tons of MG-Si every year. Therefore, it is of great significance to recover the elemental silicon from MGSRS. However, because silicon is tightly wrapped by slag and difficult to separate, this resulting in the difficulty of silicon recovery. In this study, silicon recovery powders were obtained through the process of grinding liberation and flotation separation. The effect of grinding time on the liberation of MGSRS and the flotation recovery of silicon was studied. The liberation mechanism of MGSRS was further discussed. The results showed that the liberation degree of silicon particles was 79.45% (grinding for 15 min), which was 7.94% higher than that of silicon particles after 5 min grinding time, and 77.15% of the silicon particles were fully liberated. The flotation recovery of silicon can increase from 10.5 to 78.7% with the appropriate collector. Mechanism study showed that during the grinding process, silicon was separated along the (111) surface, and Ca 2 Al 2 SiO 7 had the largest amount of liberation along the (211) plane. More unsaturated sites of aluminum and calcium ions were observed on the silicate surface, which were favorable for adsorption with the reagent and beneficial to the silicon recovery. These results indicated that the silicon and slag of MGSRS can be sufficiently separated through grinding and flotation, and the purity of recovered silicon was about 70%. The silicon resources in MGSRS were recovered economically and could be used as the raw materials for the preparation of silicon alloy and high purity silicon.

Separation and purification of silicon from cutting kerf-loss slurry waste by electromagnetic and slag treatment technology

Recovery and Purification of Metallic Silicon from Waste Silicon Slag in Electromagnetic Induction Furnace by Slag Refining Method

A High-Efficiency and Energy-Saving Method for Purifying Industrial Silicon for Silicone Use

Separating and Recycling of Elemental Silicon from Wasted Industrial Silicon Slag

Oxygen removal and silicon recovery from polycrystalline silicon kerf loss by combining vacuum magnesium thermal reduction and hydrochloric acid leaching

Separation of Al-Si-Fe-(Mn/Cr) melts for simultaneous recycle of Al-Si scraps and purification of silicon

Enhancing the separation of Fe/Al/Ca impurities from metallurgical silicon to purify by slagging-directional solidification

Recycling of silicon scraps by electron beam melting coupled with directional solidification and its mechanism of impurity removal

Study on the Separation and Sedimentation Performance of Silicon from Diamond Wire Saw Silicon Powder Slurry

Efficient Recovery of Silicon from Silicon Slag by Interface Modification Combined with Flotation

Study of the Preparation of High Purity Silicon by a New Electro-thermal Metallurgy Method

Recovery of Ti-bearing blast furnace slag and diamond wire saw silicon powder waste by alloying and electromagnetic separation technique

Effect of Grinding Liberation on Recovery of Silicon from MG-Si Waste Slag by Flotation

Preparation of High-Quality Silicon with Silicon Cutting Waste by a Carbothermal Reduction Method

Recycle of silicon slurry cutting waste to prepare high purity SiC by salt-assisted carbothermic reduction

Separation of SiC from Si by addition of Al with electromagnetic induction melting

The use of vacuum refining to separate Ca, Al, and P from crude metallurgical grade silicon

Recycling of carbonized rice husk for producing high purity silicon by the combination of electric arc smelting and slag refining

Recycling of Ti and Si from Ti-bearing blast furnace slag and diamond wire saw silicon waste by flux alloying technique

Purification of Organosilicon Waste Silicon Powder with Hydrometallurgy

Removal of impurities from metallurgical grade silicon by addition of ZnO to calcium silicate slag