Abstract:Due to the small neutron absorption cross section and excellent thermal creep performance, zirconium alloy is one of the most important cladding materials for fuel rods in commercial fission reactors. However, quantitative analysis of the effects of temperature and grain boundaries on the corrosion microstructure evolution of zirconium alloys is still needed. The establishing of a phase field simulation for the corrosion process of polycrystalline zirconium alloy and the systematical investigating of the thermodynamic influence are both very important. In this study, the phase field model of the corrosion process in zirconium alloys is developed by combining corrosion electrochemistry through calculating the interfacial energy at the metal-oxide and oxide-fluid boundaries. Then the model is used to investigate the uniform corrosion behavior on the surface of Zr-2.5Sn alloy, which demonstrates that the corrosion kinetic curve follows a cubic rule. Subsequently, the influence of temperature on the corrosion thickening curve of zirconium alloy is examined, and good agreement between simulation and experimental results is achieved. It is observed that during early stage of oxide layer formation, there is a high growth rate with minimal temperature dependence; however, as the oxide layer thickness increases, temperature becomes a significant factor affecting its growth rate, with higher temperatures resulting in faster corrosion rates. Furthermore, the effect of polycrystalline zirconium alloy matrices on corrosion rate is investigated, revealing that the grain boundaries accelerate oxide layer thickening due to enhanced oxygen diffusion rates. At metal-oxide interface, O2- bands are formed in areas with higher O2- concentration along these grain boundaries towards the metal matrix, which mainly influences oxidationcorrosion rate during the initial oxidation stage.

Corrosion Kinetics and Mechanisms of ZrC1-x Ceramics in High Temperature Water Vapor

Water Vapor Oxidation Behavior and Mechanism of High-Entropy (tizrnbtacr)c at 1200°C

Formation of Intragranular Nanocavities in the Cr 2 O 3 Layer During the Corrosion of Cr 3 C 2+cr Coated Zirlo TM

Hot corrosion behaviors of SrZrO3 ceramic co-doped with Y2O3 and Yb2O3 in molten Na2SO4, V2O5, and Na2SO4 + V2O5 salts mixture

Microstructure Evolution and Failure Mechanism of Cr-coated Zry-4 in Air and Steam at 1200 °C

Hydrothermal corrosion of Cr C and Ti-Al-C carbide ceramic coatings on Zircaloy: Corrosion behavior, mechanism and influence of water exposure on pressurized steam oxidation resistance

Improving the Comprehensive Properties of ZrO2–C Materials with Aid of TiO2 Addition

Phase-field Simulation of High-Temperature Corrosion of Binary Zr-2.5Sn Alloy

The Oxidation Behavior and Corrosion Mechanism of SiC Matrix Ceramics in a High Temperature Wet Air Environment

Temperature sensitivity and transition kinetics of uniform corrosion of zirconium alloys in superheated steam

Steam oxidation of Cr-coated zirconium alloy claddings at 1200 °C: Kinetics transition and failure mechanism of Cr coatings

Systematic Investigations on the Coating Degradation Mechanism During the Steam Oxidation of Cr-coated Zry-4 at 1200 °C

Oxidation Behavior of Cr-coated Zirconium Alloy Cladding in High-Temperature Steam above 1200 °C

Evolution of Cr/Cr2O3 interface in Cr-coated zirconium alloy in high temperature steam

Corrosion Behavior and Mechanisms of Al2O3 and Mo Coated Zircaloy-4 in High-Temperature Lithiated Water

Stability and Reactivity of Zirconium Diboride in Intermediate-Temperature Hydrothermal Conditions: A Comprehensive Analysis

Understanding Ion Transport Mechanisms of Chromium-Coated Zirconium Alloy Cladding in Steam Oxidation

Study on eutectic-oxidation coupling reaction of Cr-Zr system in high temperature steam environment

Design and Preparation of an Ultra-High Temperature Ceramic by In-Situ Introduction of Zr2[Al(Si)]4C5 into ZrB2-SiC: Investigation on the Mechanical Properties and Oxidation Behavior

Formation Mechanism and High Temperature Mechanical Property Characterization of Sic Depletion Layer in Zrb2/Sic Ceramics

Microstructure and Mechanical Properties of ZrC Coating on Zirconium Fabricated by Interstitial Carburization