Abstract:This study focused on the numerical simulation of the distribution of residual stress in yttria-stabilized zirconia (YSZ) coatings prepared with atmospheric plasma spraying (APS). We particularly investigated the stress distribution around the interface between the top coat and bond coat. During thermal spray deposition, droplets and particles deposit on the substrate in a complex manner, causing interface waviness and non-uniform stress distribution. Therefore, residual stress is an important consideration when preparing thermal barrier coatings (TBCs). Residual stresses directly affect the performance of bond coats (BCs) and ceramic top coats (TCs). To accurately evaluate residual stress, we considered interface waviness and the thickness of the ceramic top coat and conducted a detailed analysis of stress distribution. The results show that compressive stress exists at the TC/BC interface, which may be caused by the mismatch in the thermal expansion coefficient between the YSZ top coat and the substrate, potentially leading to coating delamination. Moreover, the residual stress at the TC/BC interface significantly increases with an increasing YSZ thickness. When the top-coat thickness exceeds 300 μm, stress concentration and failure of the coating are likely to occur. Meanwhile, the optimized thermal spray experiment results confirm that the residual stress at the BC/YSZ interface of the thermal barrier coating is tensile stress, with a maximum value of 155 MPa, which is consistent with the finite element calculation results. Furthermore, the failure modes of TBCs with rough interface conditions are discussed in detail. Our research provides important guidance for TBC design and optimizing their performance.

Effect of Temperature on the Residual Stress of a Β-Pbo2 Coating

Effect of substrate temperature on microstructure and residual stress of EB-PVD ZrO2 coating

The effects of substrate temperature on the residual stress for EBPVD

The Effects of Substrate Temperature on the Residual Stress for EBPVD TBCs

Effect of Thermal Cycling Evolution on Residual Stress of High Emissivity Coating on Ni-Based Superalloy Sheet

Effects of oxide thickness, Al2O3 interlayer and interface asperity on residual stresses in thermal barrier coatings

Effects of Residual Stress on the Mechanical Properties of Plasma-Sprayed Thermal Barrier Coatings

Effect of Interlayer on the Residual Stresses Within High-Temperature Coating

Effect of Residual Stress on the Spallation of the Thermally-Grown Oxide Formed on NiCoCrAlY Coating

Effect of the thermally grown oxide and interfacial roughness on stress distribution in environmental barrier coatings

Effect of Deposition Temperature on Long-Term Residual Stress Evolution of Au Films

Influences of Deposition Temperature on Microstructure and Properties of CrB2 Coatings

The Influence of Bondcoat and Topcoat Mechanical Properties on Stress Development in Thermal Barrier Coating Systems

Effect of As-Deposited Residual Stress on Transition Temperature of VO2 Films

Residual Stress Distributions Within High-Temperature Coatings

Effect of Top-Coat Thickness and Interface Fluctuation on the Residual Stress in APS-TBCs

Effect of pre-oxidation on the failure mechanisms of EB-PVD thermal barrier coatings with (Ni,Pt)Al bond coats

Microstructure Parameters Affecting Interfacial Adhesion of Thermal Barrier Coatings by the EB-PVD Method

Characterization and Understanding of Residual Stresses in a NiCoCrAlY Bond Coat for Thermal Barrier Coating Application

Progress for effect of heat treatment on properties of electroless plating

Internal Stress on Adhesion of Hard Coatings Synthesized by Multi-Arc Ion Plating