Abstract:We propose a methodology for the rheological characterization of a semisolid metal slurry using experimental squeeze flow data. The slurry is modeled as a structural thixotropic viscoplastic material, obeying the regularized Herschel-Bulkley constitutive equation. All rheological parameters are assumed to vary with the structure parameter that is governed by a first-order kinetics accounting for the material structure breakdown and build-up. The squeeze flow is simulated using finite elements in a Lagrangian framework. The evolution of the sample height has been studied for wide ranges of the Bingham and Reynolds numbers, the power-law exponent as well as the kinetics parameters of the structure parameter. Systematic comparisons have been carried out with available experimental data on a semisolid aluminium alloy (A356), where the sample is compressed from its topside under a specified strain of 80% at a temperature of 582 oC while the bottom side remains fixed. Excellent agreement with the experimental data could be achieved provided that at the initial instances (up to 0.01s) of the experiment the applied load is much higher than the nominal experimental load and that the yield stress and the power-law exponent vary linearly with the structure parameter. The first assumption implies that a different model, such as an elastoviscoplastic one, needs to be employed during the initial stages of the experiment. As for the second one, the evolution of the sample height can be reproduced allowing the yield stress to vary from 0 (no structure) to a maximum nominal value (full structure) and the power-law exponent from 0.2 to 1.4, i.e., from the shear-thinning to the shear-thickening regime. These variations are consistent with the internal microstructure variation pattern known to be exhibited by semisolid slurries.

Rheological Behavior of Semisolid A356 Alloy with Different Morphology of Primary Α Phases

The Influences of the Microstructure Morphology of A356 Alloy on Its Rheological Behavior in the Semi-Solid State

Unexpected Dynamic Recrystallization Behavior of Ti-7Cu Alloy in Semi-Solid State

Rheologic Properties of Aluminum Alloy A356 Bille ts Produced by Semisolid Continuous Casting Process

Static Shearing Rheological Behavior of Semi-solid A356 Alloy

Fatigue property of semisolid A357 aluminum alloy under different heat treatment conditions

Rheological Behavior of the A356 Alloy in the Semisolid State at Low Shear Rates

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

On the Size Effects in Micro/meso Semisolid Extrusion–forging of A356 Aluminum Alloy

Comparison of Rheological Models to Simulate Die Filling Process of A356 Semisolid Alloy

Microstructural Features of Semi-Solid A357 Alloy Slurry Under High-Shear Melt Processing

New technique for preparing A356 alloy semisolid slurry and its rheo-diecast microstructure and properties

Development of Rheometer for Semi-Solid High-Melting Point Alloys

The solidification characteristics of 6061 and A356 aluminum alloys and their ceramic particle-reinforced composites

Determination of the Solidification Chracteristics of the A356.2 Aluminum Alloy

Microstructural Features and Wear Characteristics of Semi-Solid Processed A356 Aluminum Alloy

Tensile properties and fractography of A356 alloy produced by EPSC-VL process

Experimental Studies on Rheocasting Processing of A356 Alloy

Rheological characterization of a thixotropic semisolid slurry by means of numerical simulations of squeeze flow experiments

Semi-solid compression of 2A14 alloy with high solid fraction: rheology, constitutive equation and microstructure

Microstructure characteristics and strengthening mechanism of semisolid CuSn10P1 alloys