Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Stabilization of Free CaO in Molten BOF Slag by Addition of Silica at High Temperature

Free CaO Stabilisation by Mixing of BF Slag and BOF Slag in Molten State

Accelerated carbonation and stabilization of BOF slag: data fitting relationship between particle size and CO2 sequestration

The study on the reconstruction and evolution pathway of free lime by hot stage mixing molten ironmaking and steelmaking slags in a laboratory

Numerical Investigation of Basic Oxygen Furnace Slag Modification with Gas Bottom-Blowing and SiO2 Modifier

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Study on f-CaO digestion mechanism of high alkalinity slags with iron ore tailings

Effect of Cr2O3 on Physicochemical Properties of CaO-SiO2-FetO Slags during BOF Smelting Process of Chromium-Bearing Iron

Evolution of Interface Characteristic between Quicklime and CaO–SiO2–FetO–MgO Melt during Slag‐Forming Procedure in Converter under Different Times

Volumetric stability control of steel slag and its mechanism research

Effect of CaO/MgO on Rheological Properties and Structure of CaO-MgO-SiO2-Al2O3-50% TiO2 Slag with SiO2/Al2O3=1.0

Dissolution of Al2O3–C bricks in 45 wt% CaO-45 wt% SiO2-x wt% CaF2-(10-x) wt% Na2O slag

Influences of CaO/SiO2/MgO/Al2O3 on the Formation Behavior of FeO-Bearing Primary-Slags in Blast Furnace

Fluidity and Structure of Aluminate Slags for Smelting High-Alumina Iron Ores: Effect of CaO/SiO2 Mass Ratio

Iron Recovery and Active Residue Production from Basic Oxygen Furnace (BOF) Slag for Supplementary Cementitious Materials

Dissolution of Carbon-Containing Species in CaO-SiO 2 -Al 2 O 3 Slag

Study on Rapid Stabilization of Steel Slag Powder

Effect of SiO2 and B2O3 on crystallization and structure of CaF2-CaO-Al2O3-based slag for electroslag remelting of ultra-supercritical rotor steel

Optimization of f-MgO/f-CaO phase in ladle furnace slag by air rapidly cooling

Effect of CeO2 Content on Melting Performance and Microstructure of CaO-Al2O3-SiO2-MgO Refining Slag

Mineral Sequestration of CO2 Using Basic Oxygen Furnace (BOF) Steelmaking Slag