Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Effect of CeO2 Content on Melting Performance and Microstructure of CaO-Al2O3-SiO2-MgO Refining Slag

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Effects of TiO2 and CaO/Al2O3 on Melting Characteristics, Surface Tension, and Structure Electroslag‐Remelting‐Type Low‐Fluorine Slag

Effect of B2O3 on the Melting Temperature and Viscosity of CaO–SiO2–MgO–Al2O3–TiO2–Cr2O3 Slag

Effect of Ce2O3 on the fluoride vaporization of CaF2–CaO–Al2O3-(Ce2O3) slag used for vacuum electroslag remelting

Effect of W(mgo)/w(al2o3) Ratio and Basicity on Microstructure and Metallurgical Properties of Blast Furnace Slag

The Interface Characteristics of High-Temperature Melt of CaO-Al2O3-MgO-SiO2 System

Structure and viscosity of slags containing cerium oxide

Polymeric Structure Evolution Behavior Analysis of Aluminosilicate-Based Smelting Slag

Softening–Melting Behaviors of a MgO-SiO2-FeO Slag System on a Coke Bed

The Study on the Interface Reaction Characteristics of Different Binary Slag, CaO – MgO, Al2O3 – CaO, Al2O3 – MgO, SiO2 – CaO, SiO2 - MgO

Effect of Mass Fraction of CeO2 on Leaching Resistance of Sodium Aluminosilicate Glass

Deoxidation of Molten Steel with CaO-Al_2O_3 Based Refining Slag

Melting Performance for Selected CaO-5%MgO-Al_2O_3-SiO_2-0.5%‘FeO' Slag With Low Silica

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Effect of Al2O3/SiO2 mass ratio and CaO content on viscosity and structure of slag for pyrometallurgical processing of spent automotive catalysts

Thermophysical Properties of CaO–SiO2–Al2O3–MgO–TiO2–FeOx–V2O3 Slag with CaO/SiO2 = 1.13 with Different TiO2 and V2O3 Additions

Effect of unmelted lime on the element distribution behavior on a CaO-SiO2-MgO-Al2O3-FeO-CaF2(-Cr2O3) slag

Influence of TiO2 on the liquidus temperature and structure of CaO-SiO2-Fe2O3-TiO2 slags

Understanding the Relationship Between Structure and Thermophysical Properties of CaO-SiO 2 -Mgo-al 2 O 3 Molten Slags

Effect of Al2O3 Addition on the Phase Equilibria Relations of CaO-SiO2-5 Wt%mgo-Al2o3-tio2 System Relevant to Ti-bearing Blast Furnace Slag