Abstract:Resonator Fiber optic gyro (RFOG) is a high accuracy inertial rotation sensor based on the Sagnac effect. The optical fiber ring resonator (OFRR) is the key rotation sensing element. The backscattering characteristics of the OFRR are fully investigated. The Rayleigh backscattering dominates the backscattering spectrum with the input power below the threshold. High carrier suppression is crucial to reduce this Rayleigh backscattering error. Being different from the intrinsic Rayleigh scattering of the fiber, the stimulated Brillouin scattering (SBS) in the OFRR should be avoided. This is because the finesse and the resonance notch depth of the OFRR decrease for the pump depletion through the SBS process. The shot noise limited sensitivity (SLS) of the RFOG is improved by increasing the input power. Through analysis, it is found that the threshold input power is improved after phase modulation. The SLS of the RFOG is analyzed at different modulation parameters and its relevant SBS threshold. Accordingly, the optimized modulation frequency and the corresponding maximum input power are all obtained. A simple method of testing the frequency shift in the SBS is also proposed. In this method, the central frequency of the laser source is locked to the resonance frequency of the OFRR in one direction. A steady SBS light is observed and its frequency shift is measured together.

Study on phase noise induced by 1/f noise of the modulator drive circuit in high-sensitivity fiber optic gyroscope

Reduction of High-Frequency Laser Noise in Resonant Fiber Optic Gyroscope with a Phase-Modulated Feedback Loop

Temperature Modeling of Modulation Phase Error in the Integrated Optical Chip for Closed-Loop Interferometric Fiber Optic Gyroscope

Influence of intensity noise on the resonant fiber optic gyroscope and restraining

IFOG Output Fluctuation Caused by Electrostriction Effect and Its Solution

The application of low-noise DC-DC power source in fiber-optic gyroscope system

Influence of the Modulation Phase Error on Bias Error in Interferometric Fiber Optic Gyroscope

Analysis on Phase Modulation Spectroscopy of Resonator Fiber Optic Gyro

An Open-Loop RFOG Based on 2nd/4th Harmonic Feedback Technique to Suppress Phase Modulation Index’s Drift

Laser Frequency Noise Measurement in a Resonant Fiber Optic Gyro

Laser frequency noise induced error in resonant fiber optic gyro due to an intermodulation effect.

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

An Open-Loop RFOG Based on Harmonic Division Technique to Suppress LD's Intensity Modulation Noise

Reduction of relative intensity noise in a broadband source-driven RFOG using a high-frequency modulation technique

Evaluation and Suppression of the Effect of Laser Frequency Noise on Resonant Fiber Optic Gyroscope

Laser Frequency Noise Power Spectral Density Measurement Technology and Its Application to Resonant Optical Fiber Gyroscope

Suppression of Phase Noise Induced by Modulation Frequency Deviation in Fiber-Optic Gyroscopes

Signal processing improvement of passive resonant fiber optic gyroscope using a reciprocal modulation-demodulation technique

Research Progress of the Resonant Fiber Optic Gyroscope Technology

Optimization of the sinusoidal phase modulation technique in resonant fiber optic gyro

Full investigation of the backscattering in resonator fiber optic gyro