Abstract:In atomic multi-level systems, adiabatic elimination is a method used to minimize complicity of the system by eliminating irrelevant and strongly coupled levels by detuning them from one-another. Such a three-level system, for instance, can be mapped onto physical in form of a three-waveguide system. Actively detuning the coupling strength between the respective waveguide modes allows modulating light propagating through the device, as proposed here. The outer waveguides act as an effective two- photonic-mode system similar to ground- and excited states of a three-level atomic system, whilst the center waveguide is partially plasmonic. In adiabatic elimination regime, the amplitude of the middle waveguide oscillates much faster in comparison to the outer waveguides leading to a vanishing field build up. As a result, the middle waveguide becomes a dark state and hence a low insertion-loss of 8 decibel is expected to keep when achieving the modulation depth as high as 70 decibel despite the involvement of a plasmonic waveguide in the design presented here. The modulation mechanism relies on switching this waveguide system from a critical coupling regime to adiabatic elimination condition via electrostatically tuning the free-carrier concentration and hence the optical index of a thin ITO layer residing in the plasmonic center waveguide. This alters the effective coupling length and the phase mismatching condition thus modulation in each of outer waveguides. Our results show a modulator energy efficiency as low as 40 atto-joule per bit and an extinction ratio of 50 decibel. Given the minuscule footprint of the modulator, the resulting lumped-element limited RC delay is expected to exceed 200 giga hertz. This type of modulator paves the way for next-generation both energy-and speed conscience optical short-reach interconnects.

Design of a Modulator Based on Hybrid SPPs Structure

Electro-Optic Silicon Modulator With Horizontal Photonic Crystal Slot Slab

Design of hybrid structure for fast and deep surface plasmon polariton modulation.

Analysis of Electrooptic Modulator With 1-D Slotted Photonic Crystal Nanobeam Cavity

Ultracompact Electrooptic Silicon Modulator With Horizontal Photonic Crystal Slotted Slab

Modulator of surface plasmon polariton based cycle branch graphene waveguide

A Wideband Electro-Optic Modulator Based on Long Range Surface Plasmon Resonances

Low Loss Hybrid Plasmon Polariton Mach-Zehnder Modulators

A Graphene-on-gap Modulator with High Modulation Efficiency

Design and Electro-Optical Co-Optimization of High-Speed Travelling Wave Silicon-Organic Hybrid Modulators

Highly Efficient Graphene-Based Optical Modulator with Edge Plasmonic Effect

High Efficiency Single-Sideband Modulator Using Coupled Bragg Grating Resonators on Thin-Film Lithium Niobate

Experimental Demonstration of a Graphene-Based Hybrid Plasmonic Modulator

A Novel Electrode Structure with a Reverse-Biased P⿿n Diode for High Speed Polymer-Infiltrated Slot Modulators

Mach-Zehnder Modulator Based on Low Loss Hybrid Plasmon Polariton Waveguide

Plasmonic Optical Modulator based on Adiabatic Coupled Waveguides

Electro-Optic Polymer Assisted Optical Switch Based on Silicon Slot Structure

InGaAsP/InP Based Q-modulated Slotted Fabry-Perot Laser Employing Lossy Half-Wave Trenches

Surface Plasmon Polariton Modulator Based on Electro-Optic Polymer

25Gbit/s Fully Cmos-Compatible Silicon Modulator Based on Interleaved Pn Junctions

High-speed Silicon Modulators for the 2 Μm Wavelength Band