Abstract:Microwave radiometers can be used in human tissue temperature measurement scenarios due to the advantages of non-destructive and non-contact temperature measurement. However, their accuracy often cannot meet the needs of practical applications. In this paper, a Ku-Band high-precision blackbody calibration target is designed to provide calibration for microwave radiometers and meet the requirements of a high temperature-measurement accuracy and high temperature-measurement resolution. From a practical application point of view, the blackbody calibration target needs to have the characteristics of high emissivity and high temperature uniformity. However, previous studies on blackbody calibration targets often focused on the scattering characteristics or temperature uniformity of the calibration target separately, and thus lack a comprehensive consideration of the two characteristics. In this paper, the electromagnetic scattering model and the temperature-distribution model of the calibration target are established through the multi-physical simulation combined with the Finite Element Method. Then, according to the simulation results of the two characteristic models, the structural parameters and composition of the coated cone array are continuously optimized. In addition, to achieve high-precision temperature control of the blackbody calibration target, this paper studies three PID controller parameter self-tuning algorithms, namely, BP-PID, PSO-PID and Fuzzy-PID for the optimal parameter tuning problem of traditional PID algorithms and determines the optimal temperature-control algorithm by comparing the performance of heating and cooling processes. Then, the blackbody calibration target is processed and manufactured. The arch test system is used to validate the reflectance of the calibration target, the emissivity is calculated indirectly, and the temperature-distribution uniformity of the temperature-control panel of the calibration target is tested by a multi-point distribution method. Finally, the uncertainty of the brightness temperature of the blackbody calibration target is analyzed.

Effects of Coating Material Properties on the Wideband Reflectivity Performance of Microwave Calibration Targets

On the Antenna Illumination Effects in Monostatic Reflectivity Determination for Microwave Calibration Targets

Design and Implementation of a Ku-Band High-Precision Blackbody Calibration Target

Optimized Design of the Wave-Absorbing Coating Made of Carbonyl Iron Powders

Constructing and Optimizing Epoxy Resin-based Carbon Nanotube/Barium Ferrite Microwave Absorbing Coating System

Simulation of multiple composite coatings based on conducting plate and investigation of microwave reflectivity

Co-Evaluation of Reflection Loss and Surface Wave Attenuation for Magnetic Absorbing Material

A Nanocomposite Coating Improving the Accuracy in Infrared Temperature Measurement for Thermal Micro-Devices

Optical Modeling of Black Carbon with Different Coating Materials: the Effect of Coating Configurations

A Miniaturized Spot-Focusing Microwave Sensor for Broad-Band Reflectivity Measurements

Anti-reflection coating with mullite and Duroid for large-diameter cryogenic sapphire and alumina optics

Simultaneous Measurement of Thickness and Sound Velocity of Porous Coatings Based on the Ultrasonic Complex Reflection Coefficient

Anechoic Effect of Coating Covered on Target Submerged in Typical Shallow-water Waveguides

A cryogenic infrared calibration target

Design and Optical Characteristics Test of Airborne Remote Sensing Calibration Targets

Matching design and mismatching analysis towards radar absorbing coatings based on conducting plate

Effect of Microstructure on Backwall Signal Attenuation Measurements Using Focused Transducers

Multi-Material Coatings with Reduced Thermal Noise

Microstructural Effect on Radiative Scattering Coefficient and Asymmetry Factor of Anisotropic Thermal Barrier Coatings

Effect of interference on thermal noise and coating optimization in dielectric mirrors

Microwave cavity resonator sensor with an octagonal cross section for thickness measurement of coatings on carbon fibre composites