Abstract:The traditional choice of insulation material for offshore LNG transportation with type C independent tank was polyurethane foam (PUF). However, aiming to further cut down the insulation cost and spare additional arrangement space, the requirement of searching for the alternative materials still exists. Polyisocyanurate board (PIRB) and silica aerogel blanket (SAB) are chosen as candidates in this study since these two materials have been proved to be available in other fields. Despites their advantages, the seams and joints due to the specific installation techniques for PIRB and SAB could be the causes of potential defects when transporting cryogenic liquid. In this paper, the comparative study of three materials associated with their specific installation techniques was conducted to discuss if PIRB and SAB are available for offshore LNG transportation. Therein, the insulation performances were investigated through the evaporation experiment of LN2 with a 1.5 m3 type C experimental tank. The equivalent conductive model was adopted in the numerical analysis with finite element method (FEM) to determine the temperature field of insulation and the absorbed heat from the LN2 evaporation. It is proved that three types of insulation materials are well behaved and available for transporting cryogenic liquid. In respect of the thermal resistance, the ranking of three types of insulation materials is: SAB, SPF and PIRB. Higher thermal resistance of insulation leads to thinner thickness and additional arrangement space in the cargo hold, and more ship construction cost can be cut down due to the possible scaling down of ship dimensions. However, from the perspective of insulation material cost, the cost reduction due to the insulation thickness decrease is not significant as the tank continually scales up, and it is more practical to apply SPF or PIRB on a full-scale type C independent tank.

Design and Analysis of the Thermal Insulation System for a New Independent Type B LNG Carrier

Boil off rate test for containment system of new independent type B LNG mock up tank

Numerical Simulation and Experiment Verification of the Static Boil-off Rate and Temperature Field for a New Independent Type B Liquefied Natural Gas Ship Mock Up Tank

Research on Temperature Field and Thermal Stress of Liquefied Natural Gas Carrier with Incomplete Insulation

Numerical investigation of an ice-breaking LNGC cargo containment system based on experimental verification

Numerical simulation analysis of a heat transfer tube in SuperORV

A Hydrodynamical Study on Motions and Mooring Loads of the Small Scale LNG Carrier

The Daily Evaporation Rate Test and Conversion Method for a New Independent Type B LNG Mock-Up Tank

Study on damaged expanded water-repellent perlite insulation integrating neural network and simulation on temperature field and Boil-off Rate in a Liquefied Natural Gas Cargo Containment

Design of Thermal Insulation for Lng Tanker

A Numerical Method for Analysing the Responses of Cargo Containment System of an LNGC under Iceberg Collision

Multimode Coupled Failure Assessment of an LNGC Cargo Containment System Considering Flexible Boundary Condition

Comparative study of three insulation materials installed on type C independent tank for offshore LNG transportation

Effect of Partial Failure of Self-Supporting Prismatic Type B Liquefied Natural Gas Carriers' Thermal Insulation Layer on Structure Safety

Feasible Analysis of a New-Type Insulation Scheme with Gas Recovery for Large Liquid Hydrogen Tanks

Finite element analysis of strength of mobile cryogenic LNG storage tank

Fuel Gas Supply System in a LH2-Fueled Ship

Experimental Measurements and Evaluation of the Expanded Water Repellent Perlite Used for the Cargo Containment System of LNG Carrier

Nonlinear Response of Partial Ship Structure Caused by Ultra-low Temperature

Nonlinear Thermal Stress Analysis of a Partial Structure of an LNG Carrier

Equivalent Static Load Coefficient of Membrane-Type LNG Cargo Containment System