Abstract:This paper presents an explicit dynamic procedure based finite element framework to investigate the quasi static bending collapse behavior of composite thin-walled lenticular tubes (CTLTs). A detailed description of the boundary conditions and loads adopted for pure bending tests, and of determining appropriate analysis parameters that control the quasi-static process, such as the simulation time duration and damping coefficient, is given with simulation tests. The quasi-static condition is ensured by using energy balance assessments and the accuracy of the results is verified against true static simulation results reported previously. The collapse performances of a particular CTLT were evaluated numerically in two bending directions. Two distinct regimes were observed, namely, a pre-collapse regime and a post-collapse regime, and the collapse peak moment and critical bending angle that mark the division of the two regimes were predicted. It is shown that as the bending angle increases progressively, the CTLT first bends and buckles into periodic wrinkling patterns at the locally compressed region in the pre-collapse stage, and then after collapsing into the post-collapse stage, the bending moment drops rapidly and the wrinkling patterns evolve into localized ridges and folds, and finally the deformation is concentrated at a certain position of the compressed region.

Bending Collapse of Folded Tubes

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Collapse Of Tubes Under Combined Bending And Axial Compression Loads

Three-point bending collapse of thin-walled rectangular beams

Bending collapse of square tubes with variable thickness

Axial crushing of tubes fabricated by metal sheet bending

Buckling and Energy Absorption of Novel Pre-Folded Tubes under Axial Impacts

Tube Collapse under Combined External Pressure, Tension and Bending

A Dynamic Finite Element Procedure for Bending Collapse of Composite Thin-Walled Lenticular Tubes

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Quasi-Static Axial Compression of Triangular Steel Tubes

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Experimental and Numerical Investigation on Bending Collapse of Embedded Multi-Cell Tubes

Study on the Pressure Bearing Capability of Folded Multi-Port Flat Tube

Bending Collapse of Multi-Cell Tubes

Collapse of Thick Tubes under Combined Tension and Bending

Three-point bending of thin-walled rectangular section tubes with indentation mode

Mechanical behavior of thin tubes under combined axial compression and bending

Finite element simulation of 3D bending process of tube

Energy Absorption of Folded Shrink Tubes with Gradient Stiffness