Abstract:This paper aims to explore the failure modes and crashworthiness characteristics of double hat shaped tubes made of weave carbon fiber reinforced plastic (CFRP) subjected to quasi-static axial crushing and transverse bending. Experimental investigations were carried out into three different thicknesses of the composite tubes fabricated by the bladder molding process. Three distinct failure modes, classified as progressive end crushing (I), unstable local buckling (II) and mid-length collapse (III), were observed in the axial crushing tests, whereas only one similar progressive collapse mode was observed in transverse bending tests. It is shown that the thickness is a critical parameter affecting the failure mode and energy absorption capability, leading to the increase in the peak load and specific energy absorption (SEA) during the tests. The SEA of the tested double hat shaped tubes under axial crushing ranges from 60 to 90J/g, which is marginally higher than that of regular sectional CFRP tubes but over 2 times of that of conventional metallic tubes. By comparison, the load bearing and energy absorption capabilities of the tubes under transverse bending are much lower than those of the axially compressed tubes (less than 10% and 1%, respectively).

Collapse of Thick Tubes under Combined Tension and Bending

Tube Collapse under Combined External Pressure, Tension and Bending

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Collapse Of Tubes Under Combined Bending And Axial Compression Loads

Load-carrying capacity of welded hollow spherical joints subject to combined planar tri-directional axial force and bending moment

Mechanical behavior of thin tubes under combined axial compression and bending

Effect of Torsion on Collapse Bending Moment for 24-Inch Diameter Schedule 80 Pipes with Wall Thinning

Evaluation of Torsion and Bending Collapse Moments for Pipes with Local Wall Thinning

Collapse Loads for Circumferentially Through-Wall Cracked Pipes Subjected to Combined Torsion and Bending Moments

Limit bending moment for pipes with two circumferential flaws under combined internal pressure and bending

An Analytical Study for Global Buckling of Circular Tubes under Axial and Oblique Compression

Collapse Capacity of Corroded Pipes under Combined Pressure, Longitudinal Force and Bending

Inclusion of Torsion with Bending and Pressure Loads for Pipes with Thin-Wall Regions

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

On the Collapse Failure of Dented Pipes under Bending Moment and External Pressure

Bending Strength of Thin-Walled Centrifugal Concrete-Filled Steel Tubes

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Seismic Behavior of Steel Tube Confined RC Columns under Compression-Bending-torsion Combined Load

Quasi-static Axial Crushing and Transverse Bending of Double Hat Shaped CFRP Tubes

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

Behavior of Thin-Walled Dodecagonal Section Double Skin Concrete-Filled Steel Tubes under Bending