Abstract:Layer structured oxides with transition metals such as Ni, Co, and Mn have been considered as good cathode materials to replace LiCoO2 for lithium batteries due to their lower cost and higher capacity. The thermal instability in charged, especially over charged states at elevated temperatures, however, is still a major concern on this class of materials. Recently, we have developed a technique using the combination of a high intensity synchrotron x-ray beam and a fast image plate detector to do time resolved x-ray diffraction during the thermal decomposition of charged cathode materials in the presence of electrolyte. In order to understand the controlling mechanism of thermal runaway of the electrodes in Li-ion cells, we have monitored structural changes of the charged nickel-based cathode materials in the presence of electrolyte. We have also developed synchrotron based in situ and ex situ soft x-ray absorption spectroscopy (XAS) techniques which allows us to distinguish the structural differences between surface and bulk of electrodes using both electron yield (EY) and fluorescence yield (FY) detectors simultaneously. In this presentation, we will report our studies on the structural changes of cathode materials during heating with and without the presence of the electrolytes, as well as the structural differences between the surface and the bulk during heating. Our recent studies on Co, Al, Mn doped LiNiO2-based materials using time-resolved X-ray diffraction (XRD) and X-ray absorption spectroscopy (XAS) with or without the presence of electrolyte show a series of phase transformations during heating [1]. However, due to the averaging nature of X-ray techniques, detailed information about how the structure changes initiated and propagated through new phase nucleation and growth in the microscopic level is quite limited. Therefore further studies using a local probe with high spatial resolution are needed. Here, we present our insitu transmission electron microscopy (TEM) studies on the structural changes of over charged Li0.0Ni0.8Co0.15Al0.05O2 and Li0.0Ni1/3Co1/3Mn1/3O cathode materials during heating, in comparison with our XRD and XAS studies. High resolution transmission electron microscopy (HRTEM) and electron diffraction were carried out using JEM-3000F equipped with an ultra high resolution (UHR) objective-lens pole-piece, an offaxis 1024 x 1024 Gatan slow-scan camera, a post column Gatan imaging filter (GIF), a NORAN X-ray detector, and a Gatan double-tilt heating stage capable with temperature ranging from room temperature to 1000 oC. The Li0.0Ni0.8Co0.15Al0.05O2 particles harvested from overcharged cell were first examined at room temperature. Electron diffraction and HRTEM show that the main phase is a layered structure with rhombohedral symmetry. Interestingly, rock-salt structure and spinel structure, which only observed at elevated temperatures using X-ray techniques, were presented at the edges and thin areas of the particles, respectively even at room temperature. This implies that after overcharging, the particles start losing some oxygen atoms near the particle surface, resulting in the structural changes. By heating the sample, we observed that the phase with the spinel structure nucleates and grows more and more into the thick area of the particles, while the rock-salt phase propagates from the surface to the interior of the particles. After heating the sample to 400 oC, the structure of the whole sample completely transformed to the rock-salt structure. For the over-charged Li0.0Ni1/3Co1/3Mn1/3O2 sample, spinel structure was also observed on the surfaces of the particles at room temperature. The olivine-structured LiFePO4 and LiFeMPO4 (M=Mn, Co, Ni) solid solution type cathode materials have been studied intensively recently [2-8], due to their high thermal and electrochemical stabilities and good safety characteristics. The in depth understanding of the structural changes during charge-discharge cycles will provide guidance for developing new materials. Using synchrotron based in situ XRD, hard and soft x-ray XAS, and TEM, the structural changes of these materials have been studied during chargedischarge cycling. The differences of phase transition processes between the surface and the bulk will be discussed.

High‐Rate Charging Induced Intermediate Phases and Structural Changes of Layer‐Structured Cathode for Lithium‐Ion Batteries

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Fast Charge Induced Phase Evolution and Element Contribution of Nickel-Rich Layered Cathode for Lithium-Ion Batteries

Comparative Studies Between Surface and Bulk Structural Changes During Heating and Cycling for Layer-Structured and Olivine-Structured Cathode Materials

Structure Evolution and Kinetics Study of Layered LiNixMnyCozO2 (x+y+z=1) Cathode Materials During Charge Using Synchrotron X-Ray Techniques

Structural evolution of nickel-rich layered cathode material LiNi0.8Co0.1Mn0.1O2 at different current rates

Understanding the Rate Capability of High‐Energy‐Density Li‐Rich Layered Li1.2Ni0.15Co0.1Mn0.55O2 Cathode Materials

Insight into the Structural Evolution and Thermal Behavior of LiNi 0.8 Co 0.1 Mn 0.1 O 2 Cathode under Deep Charge

Lithium Transport of Fast Battery Cycles in a LiMn2O4 Cathode Imaged by Operando Eels

Atomic-Resolution In Situ Exploration of the Phase Transition Triggered Failure in a Single-Crystalline Ni-Rich Cathode

Structure Changes of Cathode Materials During Charge-Discharge

Chemical-Mechanical Effects in Ni-Rich Cathode Materials

Resolving atomic-scale phase transformation and oxygen loss mechanism in ultrahigh-nickel layered cathodes for cobalt-free lithium-ion batteries

The Effects of Reversibility of H2-H3 Phase Transition on Ni-Rich Layered Oxide Cathode for High-Energy Lithium-Ion Batteries

Phase behavior tuning enable high-safety and crack-free Ni-rich layered cathode for lithium-ion battery

Hierarchical Reactions Involving Dynamic Structural Changes in Lithium-Ion Batteries during Overcharge Using Advanced Analytical Techniques

Structural origin of overcharge-induced thermal instability of Ni-containing layered-cathodes for high-energy-density lithium batteries

Atomic Insight into the Layered/Spinel Phase Transformation in Charged LiNi0.80Co0.15Al0.05O2 Cathode Particles

Evolution of Structure and Lithium Dynamics in LiNi0.8Mn0.1Co0.1O2 (NMC811) Cathodes During Electrochemical Cycling

Origin of Rapid Delithiation In Secondary Particles Of LiNi0.8Co0.15Al0.05O2 and LiNiyMnzCo1−y−zO2 Cathodes

Interphase Modification of Li(Ni0.5Co0.2Mn0.3)O2 Based Lithium Battery Electrode Materials by Depolarized and Pre-Lithiation for High Capacity and Cycling Performance