Abstract:About 10wt.% of glycerol can be produced during the conversion of vegetable oils or animal fats into biodiesel fuel by the transesterification process. To make use of glycerol and increase its values, H2 production from catalytic steam reforming of glycerol by Ni–Mg–Al based catalysts was evaluated experimentally in a fixed-bed reactor under atmospheric pressure within a temperature range of 450–650°C. The thermodynamic analysis was conducted by using a non-stoichiometric methodology based on the minimization of Gibbs free energy. The Ni–Mg–Al based catalysts were synthesized by the co-precipitation method with rising pH technique. The synthesized catalysts were characterized by the elemental analysis, BET, XRD and SEM methods. All the metals in the catalyst remained in oxide forms and the catalysts had the specific surface areas from 98.542 to 126.777m2/g for different compositions. The results showed that glycerol conversion and H2 selectivity were increased with increasing temperatures from 450 to 650°C. The formations of CH4 and CO in the glycerol steam reforming were almost negligible. Carbon formation in glycerol steam reforming was serious in low temperatures. The catalyst containing NiO of 24.1wt.%, MgO of 26.1wt.% and Al2O3 of 49.8wt.% performed appreciable catalytic activity, and the H2 selectivity was found to be 78.5% and conversion of glycerol was up to 88.0% at 650°C. The effects of the operating conditions including temperature, the ratio of steam to carbon (S/C), glycerol inlet concentration and flow rate of carrier gas on glycerol steam reforming by the optimized catalyst were tested. Based on a kinetic model assuming the power law with a first reaction order, the activation energy and the frequency factor for glycerol steam reforming by the Ni–Mg–Al based catalysts were calculated.

Hydrogen production from glycerol steam reforming over Ni/La/Co/Al2O3 catalyst

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

Hydrogen Production by Glycerol Reforming in a Fixed-Bed Reactor

Hydrogen production by sorption-enhanced steam reforming of glycerol.

Renewable hydrogen production from steam reforming of glycerol by Ni–Cu–Al, Ni–Cu–Mg, Ni–Mg catalysts

Hydrogen production by enhanced-sorption chemical looping steam reforming of glycerol in moving-bed reactors

Hydrogen production from steam reforming of glycerol by Ni–Mg–Al based catalysts in a fixed-bed reactor

Hydrogen Production from Glycerol Steam Reforming over Monolithic Catalyst

Activity of Ni-Cu-Al based catalyst for renewable hydrogen production from steam reforming of glycerol

Hydrogen production by glycerol reforming in a two-fixed-bed reactor

Hydrogen Production by Catalytic Steam Reforming of Heavy Components in Bio-Oil in Fluidized Bed Reactor

Hydrogen Production by Catalytic Steam Reforming of Model Compounds of Bio-Oil

Preparation of Hydrogen Through Catalytic Steam Reforming of Bio-oil

Hydrogen Production from Steam Reforming of Kerosene over Ni–La and Ni–La–K/cordierite Catalysts

Hydrogen Production by Steam Reforming of Kerosene over Ni-La-K Catalyst

Hydrogen Production Through Catalytic Steam Reforming of Simulacrum of Light Component of Bio-Oil in a Fluidized Bed Reactor

Biogas reforming for hydrogen production over Ni/γ-Al2O3 catalyst modefted with La2O3

DIMETHYL ETHER STEAM REFORMING FOR HYDROGEN PRODUCTION OVER Cu-Mn/γ-Al2O3 CATALYST

Continuous Sorption-Enhanced Steam Reforming of Glycerol to High-Purity Hydrogen Production

BIOGAS REFORMING FOR HYDROGEN PRODUCTION OVER Ni/γ-Al_2O_3 CATALYST MODEFIED WITH La_2O_3

Hydrogen Production from Ethanol Steam Reforming over Ni/Al2O3 and Ni/La2O3 Catalysts at Low Temperature