Abstract:To increase the energy density of DMFC system, increasing the methanol concentration is an excellent solution. However, the severe methanol crossover problem limits the application of Nafion in DMFCs with a highly concentrated methanol solution. Here, we proposed a feasible approach to overcome this challenge where Nafion membrane was reinforced with a covalently crosslinked quaternized poly (arylene ether ketone) (PAEK) nano fiber mat for establishing acid-base ion-paired interfaces between them. Firstly, the bromomethylated PAEK precursor was prepared into a three-dimensional fibrous support material using electrospinning. The nanofibers were then quaternized and covalently crosslinked to embed in the Nafion matrix while maintaining their fiber morphology. During the membrane fabrication, the ion-paired interfaces were established between the -N(CH3)(3)(+) on the nanofibers and -SO3- groups of Nafion matrix. The strong ion-paired interaction resulted in low membrane swelling and methanol permeability. TEM confirmed that the hydrophilic ionic clusters were aggregated with controllably distribution along the nanofibers to create long-range and efficient proton transport channels. Therefore, the hybrid membrane F-CQPAEK@Nafion-1.0 showed a high proton conductivity of 0.21 S cm(-1) at 80 C. In 2 M DMFC, the maximum power density (PDmax) of this membrane reached 119.38 mW cm(-2), 2.78 times higher than that of recast Nafion. In 10 M DMFC, the PDmax of this hybrid membrane reached 65.31 mW cm(-2), which was 3.54 times higher than that of recast Nafion. The results illustrate the possibility of running Nafion-based hybrid membranes in DMFCs with a broad operational flexibility from low concentration to high concentration methanol solutions.

Study on Methanol-Resistant MEA for DMFCs

Structure and performance of composite Nafion® membranes with Pd for DMFC

Structure and Performance of Pd-Nafion® Composite Membranes for DMFC

Mechanically Robust and Highly Methanol-Resistant Sulfonated Poly(ether Ether Ketone)/poly(vinylidene Fluoride) Nanofiber Composite Membranes for Direct Methanol Fuel Cells

Improvement of the Nafion–polytetrafluoroethylene Membranes for Potential Direct Methanol Fuel Cell Use by Reduction of the Methanol Crossover

Pd and Pd-Cu Alloy Deposited Nafion Membranes for Reduction of Methanol Crossover in Direct Methanol Fuel Cells

Comparative Studies of Configurations and Preparation Methods for Direct Methanol Fuel Cell Electrodes

Crosslinked PAEK-based Nanofiber Reinforced Nafion Membrane with Ion-Paired Interfaces Towards High-Concentration DMFC

Self-assembling multi-layer Pd nanoparticles onto Nafion™ membrane to reduce methanol crossover

Performance of an integrated composite membrane electrode assembly in DMFC

Modification of Nafion™ membrane to reduce methanol crossover via self-assembled Pd nanoparticles

MEA with double-layered catalyst cathode to mitigate methanol crossover in DMFC

Effect of Methanol Concentration on Performance of Passive DMFC

A Palladium-Alloy Deposited Nafion Membrane for Direct Methanol Fuel Cells

Research progress in methanol-rejecting PEM for DMFC

A Facile Surface Modification of Nafion Membrane by the Formation of Self-Polymerized Dopamine Nano-Layer to Enhance the Methanol Barrier Property

Optimization of Membrane Electrode Assembly in Air-Breathing Direct Methanol Fuel Cell

Optimum of Catalyst Layers for Direct Methanol Fuel Cells

Methanol-Blocking Perfluorosulfonic Acid Composite Membranes in Direct Methanol Fuel Cells

A methanol barrier polymer electrolyte membrane in direct methanol fuel cells

Investigation of a New Method to Prepare Low Methanol and Water Crossover Membrane Electrode Assembly for Passive Direct Methanol Fuel Cells