Abstract:Determination of relation between oxides melts properties, based on silicates and calcium alum-silicates and magnesium and their chemical composition and structure is an important condition to provide a rational slag mode in a continuous casting machines mold. A mathematical simulation of slag melts and casting powders accomplished. The oxide-fluoride system was chosen for the simulation, for which the structure after solidification was determined by experiment. Results of molecular-dynamic simulation of CaO–SiO2–Al2O3–MgO–Na2O–K2O–CaF2–FeO system, correspondent to industrial casting powders composition, used during steel casting for slag formation in a CCM mold (35.35 % SiO2; 30.79 % CaO; 8.58 % Al2O3; 1.26 % MgO; 13.73 % CaF2; 7.57 % Na2O; 0.88 % K2O; 1.82 % FeO). Taking into account the concentration, a re-calculation was accomplished to mole shares and correspondent number of ions in the model for each component calculated. Simulation of the 8-component oxide-fluoride melt with 2003 ions size in the main cube (a side length of 31.01 Å) was accomplished at the experimentally determined temperature of solidification onset (1257 K) under periodic boundary conditions and fixed volume. The Coulomb interaction was taken into account by the Ewald–Hansen method. The time step was 0.05t0, where t0 = 7,608×10–14 sec is the internal unit of time. The melt density was taken as 3.04 g/cm3 based on the experimental data. The inter-particle interaction potentials were chosen in the Born–Mayer form. According to the simulation results, the structure of sub-crystalline groups of atoms present in the melt at the temperature of the onset of solidification was determined. A discussion of the simulation results and their comparison with the literature data presented.

Modeling and Simulating for Alumina of Sodium Aluminate Continuous Solution Process

MODELLING AND SIMULATION OF CARBONATION PROCESS OF AMMONIACAL BRINE Ⅱ THE REACTOR/CRYSTALLIZER MODEL OF CARBONATION COLUMNS

Modeling and Simulation Research onm-Xylene Oxidation Reactor

Modelling and simulation of carbonation process of ammoniacal brine: I kinetic model of carbonation reactions

Kinetic Model and Simulation Analysis for Toluene Disproportionation and C9-Aromatics Transalkylation

Modeling and Simulation of Commercial Catalytic Reformers

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Modeling and Optimization of Ethane Steam Cracking Process in An Industrial Tubular Reactor with Improved Reaction Scheme

Modeling and Control of a Continuous Stirred Tank Reactor Based on a Mixed Logical Dynamical Model

Flowsheet Modeling and Simulation for an Industrial Soda Plant

Simulation of an industrial continuous bulk styrene polymerization process

Modeling and optimization for the continuous catalytic reforming process based on the hybrid surrogate optimization model

Modeling of Θ → Α Alumina Lateral Phase Transformation with Applications to Oxidation Kinetics of NiAl-based Alloys

Modeling of Continuous Slug Flow Cooling Crystallization towards Pharmaceutical Applications

SIMULATION OF THE STEAM-AIR COMBINED COKE CLEANING PROCESS FOR THE ETHYLENE CRACKING COILS

Modeling and Optimization of a Fractionation, Absorption, and Stabilization System in an Industrial Fluid Catalytic Cracking Process

Steady state modeling and simulation of an industrial sugar continuous crystallizer

Simulation of microstructures in solidification of aluminum twin-roll casting based on CA

Modeling and Simulation Investigations on Microstructure Evolution during Additive Manufacturing of AlSi10Mg Alloy

Numerical Modeling of Supercritical Carbonation Process in Cement-Based Materials

Mathematic simulation of atomic structure of multicomponent oxide-fluoride melt for continuous casting machines