Abstract:A mathematical model was developed to simulate the catalytic wet air oxidation (CWAO) of aqueous phenol in a trickle bed reactor (TBR). Both ‘axial dispersion’ and ‘plug flow’ models were proposed. ‘Steady-state’ mass transfers across different phases inside the reactor have all been considered in parallel with oxidation reactions catalyzed by heterogeneous copper catalyst supported on activated carbon. The changes in the concentrations of oxygen and phenol in various phases were thus depicted as a function of bed length. In order to validate the accuracy of the established TBR model, a series of experiments on phenol oxidation were performed on a pilot-scale TBR containing 5.6l of catalysts. The model was found able to give satisfactory predictions for nearly half of all the runs. The discrepancies between the experimental and modeling results were investigated for the less promising runs. It was also noticed that similar simulation results could be attained from ‘axial dispersion’ model against ‘plug flow’ model. Following the discussion on the changes of phenol and oxygen concentrations in the various phases, it is finally concluded that the performance of the TBR of this study depends largely on gas-to-liquid mass transfer process. Further suggestions with regards to reactor optimization are also proposed on the basis of experimental outcome.

Kinetic Model and Simulation Analysis for Toluene Disproportionation and C9-Aromatics Transalkylation

Kinetic Model for Hydroisomerization Reaction of C8-aromatics

Kinetic model for hydroisomerization reaction of C<sub>8</sub>-aromatics

A Seven Lumped Kinetic Model for Industrial Catalyst in DMTO Process

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Modeling, Simulation and Optimization of Commercial Naphtha Catalytic Reforming Process

Eight Lumps Kinetic Model for Residual Oil Catalytic Cracking

Cstr Model for P-Xylene Oxidation Reactor

Kinetic Modeling of C2–C7 Olefins Interconversion over ZSM-5 Catalyst

Lumped Kinetics Model and Its On-Line Application to Commercial Catalytic Naphtha Reforming Process

Modeling and Simulation Research onm-Xylene Oxidation Reactor

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Kinetics of P-Xylene Liquid-Phase Catalytic Oxidation to Terephthalic Acid

Reaction Characteristics of .Toluene Disproportionation and C9 Aromatics Transalkylation Overβ Zeolite

Modeling of a Pilot-Scale Trickle Bed Reactor for the Catalytic Oxidation of Phenol

Modeling, simulation and analysis of the liquid-phase catalytic oxidation of toluene

Kinetic modeling of gas-phase disproportionation and transalkylation of C9 and C10 aromatics over industrial zeolite catalyst

KINETIC MODELING STUDY OF FUEL-RICH PREMIXED TOLUENE FLAME AT LOW PRESSURE

Kinetic Modeling of Methanol to Olefins Process over SAPO‐34 Catalyst Based on the Dual‐cycle Reaction Mechanism

Kinetic Model of Olefins/Isobutane Alkylation Using Sulfuric Acid as Catalyst

Simulation and Optimization in the Process of Toluene Liquid-Phase Catalytic Oxidation