Abstract:The calibrator is one of the most important factors in the calibration of various laser 3D scanning instruments. The requirements for the diffuse reflection surface are emphasized in many national standards. In this study, spherical calibrator and plane calibrator comparative measurement experiments were carried out. The black ceramic standard sphere, white ceramic standard sphere, metal standard sphere, metal standard plane, and white ceramic standard plane were used to test the laser 3D scanner. In the spherical calibrator comparative measurement experiments, the results indicate that the RMS of the white ceramic spherical calibrator with a reflectance of approximately 60% is 10 times that of the metal spherical calibrator with the reflectance of approximately 15%, and the RMS of the black ceramic spherical calibrator with reflectance of approximately 11% is of the same order as the metal spherical calibrator. In the plane calibrators comparative measurement experiments, the RMS of the flatness measurement is 0.077 mm for the metal plane calibrator with a reflectance of 15%, and 2.915 mm for ceramic plane calibrator with a reflectance of 60%. The results show that when the optimal measurement distance and incident angle are selected, the reflectance of the calibrator has a great effect on the measurement results, regardless of the outlines or profiles. Based on the experiments, it is recommended to use the spherical calibrator or the standard plane with a reflectance of around 18% as the standard, which can obtain reasonable results. In addition, it is necessary to clearly provide the material category and surface reflectance information of the standard when calibrating the scanner according to the measurement standard.

Comparison Between Measurement Results from Two Types of Laser Particle Size Analyzers

Evaluation of a Wide Range Laser Particle Size Analyses and Comparison with Pipette and Sieving Methods

Measurement Results Comparison Between Laser Particle Analyzer and Sieving Method in Particle Size Distribution

An Experiment Study on Employing Laser Grain-size Analyzer to Analyze Soil Mechanical Composition

Comparison and research of grain size measurement of ultrafine powder

Determination Method of Particle Size and Distribution of Coal by Laser Size Analyzer

Laser techniques of measuring particles size and their size distribution

Comparison of Particle Size Distributions Measured Using Different Techniques

Intelligent Calibration Of Laser Particle Size Analyzer

Application of laser diffraction method in particle size determination for ion exchange resins

Measurement Analysis of Atmospheric Aerosol Aerodynamics Size with APD Detector

A statistic comparison of multi-element analysis of low atmospheric fine particles (PM2.5) using different spectroscopy techniques

Comparison of precision and accuracy in analyzing Cd in rice by LIBS combined with multivariate regression

Comparative Study of Three Types of Light Scattering Aerosol Monitor

Interlaboratory comparison of nanoparticle size measurements between NMIJ and NIST using two different types of dynamic light scattering instruments

Nondestructive measurement of the grain size of laser cladding coatings using a laser ultrasonic method

Grain Size Characterization by Laser-Based Ultrasonics Based on the Centroid Frequency Shift Method

Synchronous Measurement Method of Trans-Micron Scale Mixed Particle Size

Laser Abduction Fluorescence Spectrum for Aerosol Particle Measurement

Measurement of 2-Dimension Particle Velocity by Using-Correlation Technique on Optical Transmission Signals

Comparative Analysis on the Effect of Surface Reflectance for Laser 3D Scanner Calibrator