Abstract:ECG recorders are precision medical devices, but their thin-walled shells are susceptible to warpage and shrinkage during injection molding production due to the injection molding process, which greatly shortens their service life. To address this problem, a multiobjective optimization method for injection molding process parameters based on a combination of a BP neural network model optimized by an ant colony algorithm (ACO-BP) and an improved non-dominated sorting genetic algorithm (NSGA-II) is proposed. The study takes the warpage deformation amount and volume shrinkage rate of the plastic part as the optimization objectives, and the melt temperature, mold temperature, injection pressure, holding pressure, holding time, and cooling time as the design variables. However, for BP neural networks, it is crucial to choose an appropriate number of hidden layer neurons, so the particle swarm algorithm combined with the grey wolf algorithm (GWO-PSO) is used to solve for the optimal number of hidden layer neurons. Firstly, the number of hidden layer neurons of the BP network model was solved based on the samples obtained from the Box–Behnken experimental design and the GWO-PSO algorithm, and the ACO-BP algorithm was used to build the prediction models for warpage and volume shrinkage, respectively, and then combined with NSGA-II for global optimisation. The pareto optimal solution set was subjected to CRITIC analysis and the optimal process parameters were finally obtained, with a minimum warpage of 0.3293 mm and minimum volume shrinkage of 4.993%, a reduction of 8.93 and 6.95% respectively compared to the pre-optimisation period. At the same time, injection molding tests were carried out on the optimum process parameters, and it was found that the molding quality of the plastic parts was better and met the actual production requirements through measurement. The research in this paper provides a theoretical basis for further improving the quality defects of the thin-walled injection molded parts.

Surrogate Model and Improved Genetic Algorithm-Based Warpage Optimization of Injection Molding

An enhanced global optimization method based on Gaussian process and its application of warpage control in injection molding

Experimental-based Optimization of Polymer Injection Molding Process Parameters Using Anfis-Ga Method

Multi-objective optimization of injection molding process parameters based on BO-RFR and NSGAII methods

An Innovative Surrogate-Based Searching Method for Reducing Warpage and Cycle Time in Injection Molding

Warpage Optimization of the GFRP Injection Molding Process Parameters

Optimization of Injection Molding Process of Transparent Complex Multi-Cavity Parts Based on Kriging Model and Various Optimization Techniques

Warpage Optimization of Fiber-Reinforced Composite Injection Molding by Combining Back Propagation Neural Network and Genetic Algorithm

The Research on Gate Location Optimization of Injection Molding Based on Warpage

Optimize the Warpage of Injection Molding of Cover Based on Orthogonal Test

Multi-objective optimization of injection-molded plastic parts using entropy weight, random forest, and genetic algorithm methods

Warpage Parameter Control Design of Compressor Resign Blade Injection Molding

Optimization of the Reduction of Shrinkage and Warpage for Plastic Parts in the Injection Molding Process by Extended Adaptive Weighted Summation Method

Warpage Optimization in Injection Molding Using MPSO−HNN and MPSO Algorithm

A Modified Mode-Pursuing-Sampling Based Optimization Method for Minimization of Injection Molding Warpage

Multi-objective Optimization of GFRP Injection Molding Process Parameters, Using GA-ELM, MOFA, and GRA-TOPSIS

A method combining optimization algorithm and inverse-deformation design for improving the injection quality of box-shaped parts

Optimization of Process Parameters for Thin Plastic Shell Injection Molding Based on Neural Network and Genetic Algorithm

Quality Monitoring of Injection Molding Based on TSO-SVM and MOSSA

Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment

Quality prediction and control of thin-walled shell injection molding based on GWO-PSO, ACO-BP, and NSGA-II