Abstract:This study focuses on applying intelligent modeling methods to different injection molding process parameters, to analyze the influence of temperature distribution and warpage on the actual development of auto locks. It explores the auto locks using computer-aided engineering (CAE) simulation performance analysis and the optimization of process parameters by combining multiple quality characteristics (warpage and average temperature). In this experimental design, combinations were explored for each single objective optimization process parameter, using the Taguchi robust design process, with the L18 (21 × 37) orthogonal table. The control factors were injection time, material temperature, mold temperature, injection pressure, packing pressure, packing time, cooling liquid, and cooling temperature. The warpage and temperature distribution were analysed as performance indices. Then, signal-to-noise ratios (S/N ratios) were calculated. Gray correlation analysis, with normalization of the S/N ratio, was used to obtain the gray correlation coefficient, which was substituted into the fuzzy theory to obtain the multiple performance characteristic index. The maximum multiple performance characteristic index was used to find multiple quality characteristic-optimized process parameters. The optimal injection molding process parameters with single objective are a warpage of 0.783 mm and an average temperature of 235.23 °C. The optimal parameters with multi-objective are a warpage of 0.753 mm and an average temperature of 238.71 °C. The optimal parameters were then used to explore the different cooling designs (original cooling, square cooling, and conformal cooling), considering the effect of the plastics temperature distribution and warpage. The results showed that, based on the design of the different cooling systems, conformal cooling obtained an optimal warpage of 0.661 mm and a temperature of 237.62 °C. Furthermore, the conformal cooling system is smaller than the original cooling system; it reduces the warpage by 12.2%, and the average temperature by 0.46%.

Experimental-based Optimization of Polymer Injection Molding Process Parameters Using Anfis-Ga Method

Multi-objective Process Parameter Optimization for Energy Saving in Injection Molding Process

Multi-objective optimization of injection molding process parameters based on BO-RFR and NSGAII methods

Surrogate Model and Improved Genetic Algorithm-Based Warpage Optimization of Injection Molding

Warpage Optimization of the GFRP Injection Molding Process Parameters

Multi-objective Optimization of GFRP Injection Molding Process Parameters, Using GA-ELM, MOFA, and GRA-TOPSIS

Optimization of Injection Molding Process of Transparent Complex Multi-Cavity Parts Based on Kriging Model and Various Optimization Techniques

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Quality prediction and control of thin-walled shell injection molding based on GWO-PSO, ACO-BP, and NSGA-II

Process Parameters Optimization of Gas-assisted Injection Molding of Complex Shell Parts

Optimization of Process Parameters for Thin Plastic Shell Injection Molding Based on Neural Network and Genetic Algorithm

Optimization of injection molding process parameters to improve the mechanical performance of polymer product against impact

Influence Factor Analysis of Warpage and Optimization of Process Parameters in Plastic Injection Molding of Thin-wall Plastic Parts Based on Taguchi Optimization Method

Research on Injection Processing of Precise Plastic Part for Automobile

Injection Molding Process Optimization of Plastic Packaging Device Based on GA and BP Neural Network

Multiobjective Optimization Method for Polymer Injection Molding Based on a Genetic Algorithm

Warpage Optimization of Fiber-Reinforced Composite Injection Molding by Combining Back Propagation Neural Network and Genetic Algorithm

Multi-objective optimization of injection-molded plastic parts using entropy weight, random forest, and genetic algorithm methods

Application of Intelligent Modeling Method to Optimize the Multiple Quality Characteristics of the Injection Molding Process of Automobile Lock Parts

Mold design and forming process parameters optimization for passenger vehicle front wing plate

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation