Abstract:ECG recorders are precision medical devices, but their thin-walled shells are susceptible to warpage and shrinkage during injection molding production due to the injection molding process, which greatly shortens their service life. To address this problem, a multiobjective optimization method for injection molding process parameters based on a combination of a BP neural network model optimized by an ant colony algorithm (ACO-BP) and an improved non-dominated sorting genetic algorithm (NSGA-II) is proposed. The study takes the warpage deformation amount and volume shrinkage rate of the plastic part as the optimization objectives, and the melt temperature, mold temperature, injection pressure, holding pressure, holding time, and cooling time as the design variables. However, for BP neural networks, it is crucial to choose an appropriate number of hidden layer neurons, so the particle swarm algorithm combined with the grey wolf algorithm (GWO-PSO) is used to solve for the optimal number of hidden layer neurons. Firstly, the number of hidden layer neurons of the BP network model was solved based on the samples obtained from the Box–Behnken experimental design and the GWO-PSO algorithm, and the ACO-BP algorithm was used to build the prediction models for warpage and volume shrinkage, respectively, and then combined with NSGA-II for global optimisation. The pareto optimal solution set was subjected to CRITIC analysis and the optimal process parameters were finally obtained, with a minimum warpage of 0.3293 mm and minimum volume shrinkage of 4.993%, a reduction of 8.93 and 6.95% respectively compared to the pre-optimisation period. At the same time, injection molding tests were carried out on the optimum process parameters, and it was found that the molding quality of the plastic parts was better and met the actual production requirements through measurement. The research in this paper provides a theoretical basis for further improving the quality defects of the thin-walled injection molded parts.

Warpage Optimization of the GFRP Injection Molding Process Parameters

Surrogate Model and Improved Genetic Algorithm-Based Warpage Optimization of Injection Molding

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Injection Molding Process Optimization of Plastic Packaging Device Based on GA and BP Neural Network

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation

Warpage Parameter Control Design of Compressor Resign Blade Injection Molding

A Holistic Approach to Mitigating Warpage in Fiber-Reinforced Plastic Injection Molding for Automotive Applications

Recent progress in minimizing the warpage and shrinkage deformations by the optimization of process parameters in plastic injection molding: a review

A method combining optimization algorithm and inverse-deformation design for improving the injection quality of box-shaped parts

The Research on Gate Location Optimization of Injection Molding Based on Warpage

Mold design and forming process parameters optimization for passenger vehicle front wing plate

Quality prediction and control of thin-walled shell injection molding based on GWO-PSO, ACO-BP, and NSGA-II

Pressure Analysis Of Dynamic Injection Molding And Process Parameter Optimization For Reducing Warpage Of Injection Molded Products

Single Gate Optimization for Plastic Injection Mold

Numerical simulation of closed plastic impeller molding process and its parameter optimization

Optimization and prediction of volume shrinkage and warpage of injection-molded thin-walled parts based on neural network

Optimization of injection molding process parameters to improve the mechanical performance of polymer product against impact

Optimizing Glass Fiber Molding Process Design by Reverse Warping

Optimize the Warpage of Injection Molding of Cover Based on Orthogonal Test

Research on Intelligent Control of Thin-Walled Plastic Parts Forming Quality Based on CAE and DOE Technology

Process Parameters Optimization Using a Novel Classification Model for Plastic Injection Molding