Abstract:Volume shrinkage and warpage deformation are very critical quality indicators in the plastic injection molding (PIM) of box-shaped thin-walled plastics. These two performance indexes are greatly affected by the molding parameters. Therefore, in this paper, six optimization algorithms and inverse-deformation designs (IDD) are used to reduce volume shrinkage and warpage deformation. Firstly, six important molding parameters, namely filling time (A), plasticity temperature (B), mold temperature (C), holding time (D), maximum holding pressure (E) and cooling time (F), are determined, and the L 25 (5 6 ) orthogonal experimental design (OED) is established. Taguchi grey correlation (TGC) theory analysis is used to determine the optimal combination of molding parameters. Secondly, different combinations of Box-Behnken design (BBD) response surface method, BP neural network (BPNN) training, and NSGA-II genetic algorithms are used to generate four combined optimization algorithms, in order to perform multi-objective optimization of the six molding parameters. The result shows that the effectiveness of four optimization analyses are ranked as follows: BPNN-BBD-NSGA-II > BPNN-BBD > BBD-NSGA-II > BBD. The BPNN-BBD-NSGA-II method holds the best prediction results. Finally, a global optimization platform based on NX/Moldex3D is established considering the IDD theory to simulate the molding process. Optical scanning instruments are used to examine the molding quality. The result proves that the warpage deformation in box-shaped thin-walled injection-molded products is almost completely eliminated and a high molding quality can be achieved. This research is favorable for designing the molding process and guiding the molding of box-shaped thin-walled injection-molded products.

Single Gate Optimization for Plastic Injection Mold

Gate Location Design of Injection Molding Based on Feature Warpage Optimization

The Research on Gate Location Optimization of Injection Molding Based on Warpage

A Study of Gate Location Optimization of Plastic Injection Molding Using Sequential Linear Programming

Gate Location Optimization in Injection Molding Based on Empirical Search Method

Optimal Design of Gate Location in Injection Molding Based on Feasible Space

Gate Location Optimization Scheme for Plastic Injection Molding

Optimization of Injection Gate Location for Plastic Injection Mould Based on Optimized Filling Pattern

Determination of approximate feasible space for gate optimization of injection mold

CAE-based optimization design of gate location for cover plate

Optimization of Gating System and Shrinkage Analysis of Plastic Gear Based on Orthogonal Experimental Method

Surrogate Model and Improved Genetic Algorithm-Based Warpage Optimization of Injection Molding

Gate Location Optimization of Injection Molding Based on Fusion Mesh

Application of Moldflow in the Optimization of Gate Location in Gas-Assisted Injection Mould for Seat

Optimization of Injection Mold Based on Fuzzy Moldability Evaluation

Optimization on Injection Rate of Filling Phase in Injection Molding

Pressure Analysis Of Dynamic Injection Molding And Process Parameter Optimization For Reducing Warpage Of Injection Molded Products

A method combining optimization algorithm and inverse-deformation design for improving the injection quality of box-shaped parts

Application of Moldflow to Desigh Optimization of Injection Mold Gates

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation

Topological and Parameter Optimization Design on Front Platen of Injection Molding Machine