Slow neutron attenuation in Aluminum/Boron carbide composites

Gang LI,Tao-zhong XU,Dao-gui FU,Min JIAN
DOI: https://doi.org/10.3969/j.issn.0258-0918.2013.01.003
IF: 1.2
2013-01-01
Nuclear Science and Engineering
Abstract:Neutron transmissions through B4C/Al plates are simulated by Burrus model and Monte Carlo method.In Burrus Model,neutron beams energy is 0.025 3 eV and,B4C/Al plates thickness are 0.15 cm,0.20 cm,0.25 cm,0.30 cm,0.35 cm respectively,in which mass fraction of B4C is 20%,30%,and 40%.Burrus model results show that the higher content and the smaller particle size of B4C in B4C/Al plates are more efficient neutron absorption and lower neutron transmission rate.Neutron transmission rate in B4C/Al plates is closely with the direction of the incident angle.The maximum probability of calculated neutron transmission is a perpendicular beam through B4C/Al plates,but as the incident angle increases,i.e.normal direction angle gradually increased,neutron transmission ratio become smaller.In Monte Carlo method,the MCNP software is applied to simulate neutron beams through B4C/Al plates,and the results show that B4C/Al plates are more effective absorption neutron for 0.025 3 eV beams greater than 1.0 eV beams.
What problem does this paper attempt to address?