Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Analysis for deformation and dynamic characteristics about thin-wall part of aircraft

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Numerical Simulation and Analysis of Symmetry and Step-symmetry Milling of Aerospace Thin-walled Workpiece

602 FEM-based Simulation for Workpiece Deformation in Thin-Wall Milling

Study on Milling Deformation of Aerospace Frame Monolithic Components

Investigation of Moving Fixture on Deformation Suppression During Milling Process of Thin-Walled Structures

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Surface Topography Prediction Model in Milling of Thin-Walled Parts Considering Machining Deformation

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Finite Element Simulation and Deformation Control of High-Speed Milling of Al7050-T7451 Thin-walled Parts

Machining deformation of single-sided component based on finishing allowance optimization

Machining deformation control methods and analysis of a thin-walled gear spoke plate

Machining Deformation Prediction of Thin-Walled Workpieces in Five-Axis Flank Milling

Stability analysis of thin-walled parts end milling considering cutting depth regeneration effect

Finite element analysis of the thin-wall components’s deformation during the multi point flexible processing

Study on deformation of titanium thin-walled part in milling process

Dynamic Deformation of Thin-walled Plate with Variable Thickness under Moving Milling Force

Finite Element Simulation of Bending Thin-Walled Parts and Optimization of Cutting Parameters

Finite element analysis of residual stresses and thin plate distortion after face milling

A prediction model for the milling of thin-wall parts considering thermal-mechanical coupling and tool wear