Fabrication of Sb2S3 thin films by sputtering and post-annealing for solar cells

Chunhui Gao,Jialiang Huang,Huangxu Li,Kaiwen Sun,Yanqing Lai,Ming Jia,Liangxing Jiang,Fangyang Liu
DOI: https://doi.org/10.1016/j.ceramint.2018.10.155
IF: 5.532
2019-01-01
Ceramics International
Abstract:The semiconductor antimony sulfide (Sb2S3) is a potential absorber materials for the top sub-cell of Si-based tandem solar cells because of its appropriate band-gap, simple binary composition, nontoxic elements, and long-term stability. In this study, polycrystalline Sb2S3 films were fabricated by post-annealing of radio frequency (RF) magnetron sputtered precursors using an Sb2S3 target. The effects of the post-annealing temperature and atmosphere on Sb2S3 film properties and device performances were investigated. A high-performance device having a 2.41% power conversion efficiency was obtained by making use of a uniform Sb2S3 absorber layer. This preliminary experimental study shows that Sb2S3 thin films could be used as top sub-cell absorber materials for third-generation high efficiency, stable, and environmentally friendly Sb2S3/Si tandem solar cells.
What problem does this paper attempt to address?