Abstract:The diode-triggered silicon-controlled rectifier (DTSCR) is widely used for electrostatic discharge (ESD) protection in advanced CMOS process owing to its advantages, such as design simplification, adjustable trigger/holding voltage, low parasitic capacitance. However, the multiple-triggering effect in the typical DTSCR device may cause undesirable larger overall trigger voltage, which results in a reduced ESD safe margin. In previous research, the major cause is attributed to the higher current level required in the intrinsic SCR. The related discussions indicate that it seems to result from the current division rule between the intrinsic and parasitic SCR formed in the triggering process. In this letter, inserting a large space into the trigger diodes is proposed to get a deeper insight into this issue. The triggering current is observed to be regularly reduced along with the increased space, which confirms that the current division is determined by the parasitic resistance distributed between the intrinsic and parasitic SCR paths. The theoretical analysis is well confirmed by device simulation and transmission line pulse (TLP) test results. The reduced overall trigger voltage is achieved in the modified DTSCR structures due to the comprehensive result of the parasitic resistance vs triggering current, which indicates a minimized multipletriggering effect.

Novel Diode-Triggered SCR with Suppressed Multiple Triggering for ESD Applications

Minimizing Multiple Triggering Effect in Diode-Triggered Silicon-Controlled Rectifiers for ESD Protection Applications

Insight into Multiple-Triggering Effect in Dtscrs for Esd Protection

A Novel Technique to Suppress Multiple-Triggering Effect in Typical DTSCRs under ESD Stress

Design Analysis of a Novel Low Triggering Voltage Dual Direction SCR ESD Device in 0. 18μm Mixed Mode RFCMOS Technology

Low-leakage Diode-Triggered Silicon Controlled Rectifier for Electrostatic Discharge Protection in 0.18-Μm CMOS Process

Study of Turn-on Characteristics of SCRs for ESD Protection with TDR-O and TDR-S TLPs

A Novel Capacitance-Coupling-Triggered SCR for Low-Voltage ESD Protection Applications

A Novel Dual-Directional DTSCR in Twin-Well Process for Ultra-Low-voltage ESD Protection

A novel straight through-MOS-triggered SCR for on-chip ESD protection

Stacked Zener Trigger SCR for HV IC ESD Protection

Development of Diode Triggering SCR-Based ESD Protection Circuit with Improved Trigger Voltage for Low Voltage Application

Comparison of different MOS-triggered SCR structures for on-chip ESD protection

Inverstigation of high turn-on speed MOS-Triggered SCR in 0.13μm CMOS process

A Novel DTSCR Structure with High Holding Voltage and Enhanced Current Discharge Capability for 28 nm CMOS Technology ESD Protection

Investigation of the Trigger Voltage Walk-In Effect in Ldmos for High- Voltage Esd Protection

Novel Capacitance Coupling Complementary Dual-Direction SCR for High-Voltage ESD

Compact MOS-triggered SCR with faster turn-on speed for ESD protection

Investigation of Boundary-Mos-triggered SCR Structures for On-Chip ESD Protection

A Novel DTSCR With Embedded MOS and Island Diodes for ESD Protection of High-Speed ICs

Key factors affecting trigger voltage of SCRS for ESD protection