Abstract:There is an increasing need for lightweight structures in the transportation industry, and within these lightweight structures occupant safety is continually important to all stakeholders. Standard single and multi-material topology optimization (MMTO) techniques are effective for designing lightweight structures subjected to linear objectives and constraints but cannot consider crashworthiness. Crashworthiness must be evaluated using explicit dynamic simulation techniques, as a crash event contains geometric and material nonlinearities which cannot be captured by linear static finite element simulations. Explicit dynamic simulations prevent the calculation of sensitivity derivatives required for conventional gradient-based structural optimization strategies. This paper describes a design tool for multi-material topology optimization considering crashworthiness using the equivalent static load (ESL) method. The ESL method is used to generate linear static sub-problems which replicate the dynamic structural response of explicit dynamic crash simulations in the linear regime. The ESL sub-problems are input to a standard MMTO, optimized results from which are used as input for subsequent crash analyses to update the ESLs for additional sub-problems. The ESLs evolve as the design changes – convergence occurs when the design does not change significantly between subsequent sub-problem optimizations. The objective of this paper is to demonstrate a methodology for an efficient design tool for MMTO considering crashworthiness. Firstly, the ESL and competing methods for crashworthiness optimization are introduced and compared. Next a discussion of the tool’s operation flow as well as the sensitivity equations are presented along with two academic examples demonstrating its implementation. The design tool generates optimized multi-material designs which outperform single-material optimized designs in terms of mass by 7.5% and 17.6% in 2D and 3D models respectively when subjected to crash load cases.

Multi-objective Optimisation on Crashworthiness of Front Longitudinal Beam (FLB) Coupled with Sheet Metal Stamping Process

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Optimal Crashworthiness Design of a Spot-Welded Thin-Walled Hat Section

Optimization Design of Longitudinal Beam Structure in Car Frontal Crash

Axial crashworthiness and multi-objective optimization of single-hat beams with sinusoidal cross-sections

Crashworthiness design of vehicle structure with tailor rolled blank

Structural design of stamping die of advanced high-strength steel part for automobile based on topology optimization with variable density method

Numerical simulation and multi-objective optimization of thin-walled aluminum/carbon fiber reinforced plastic hybrid tubes under axial crushing

Numerical Optimization of Variable Blank Holder Force Trajectories in Stamping Process for Multi-Defect Reduction

Simulation of Automobile Offset Frontal Impact and Structure Improvement

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Body Structure Optimization of a Car in the Frontal Crash

FEM model optimization study of mechanical properties and material selection in stamping process

Research on Dynamic Response and Fracture Properties of Metal Materials for Vehicle

Cross-section parameterisation and optimisation of double-hat beams under dynamic three-point bending

Research on Ultra--high--strength--steel Hot Stamping Process of Automotive Anti--collision Beam

Crashworthiness analysis and multi-objective optimization of a commercial vehicle frame: A mixed meta-modeling-based method

Application and development of algorithm for sheet hydro-forming in numerical simulation

Crashworthiness analysis and design optimization of square aluminum/CFRP hybrid structures under quasi-static axial loading

Multi-Material Topology Optimization Considering Crashworthiness

Combining physics-based and data-driven methods in metal stamping