Abstract:Objective: In this research, body technology was established for side collisions with new IIHS MDB as a representative case. In the conventional body structure, most of the load received from the barrier is absorbed by bending deformation of the door beam and B-pillar, etc. For that reason, the body is subjected to large deformation before reaching the maximum load, and the deformation increases further when subjected to a high-energy collision. Therefore, the objective of this research is to create a structure that increases the load from the initiation of impact and suppresses the deformation of the car body. Method: An arched door beam was developed to reduce the bending moment by the axial load in the longitudinal direction generated during the deformation and to increase the load in the lateral direction. A principle equation was developed that uses the shape of the door beam as a variable. A prototype of the arched door beam was fabricated, and its performance was evaluated by an impactor test. A full-car simulation was conducted using a mass-produced sedan as a base, to which the arched door beam was added to verify the performance of the complete vehicle. Results: The results of the impactor tests were evaluated using the load gradient, which was defined as the generated load divided by the amount of deformation. Compared to conventional straight door beams, the load gradient was 7.1 times higher. Full-car simulation results showed that for a gasoline-powered vehicle body weight, the body load gradient of the proposed structure was 4.7 times higher, and the body deformation adjacent to the dummy shoulder was reduced by 210 mm. Spine acceleration of the dummy was reduced by 56%. Conclusion: The body structure proposed in this research has the effect of increasing the load gradient and reducing body deformation and spine acceleration. It is expected to be applicable to EVs and FCVs, which require more energy absorption due to their increased vehicle weight.

Body Structure Optimization of a Car in the Frontal Crash

Optimization Design of Body Structure in Offset Crash

Optimization Design of Longitudinal Beam Structure in Car Frontal Crash

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Frontal crashworthiness structure analysis and optimization of electric vehicle

Simulation of Automobile Offset Frontal Impact and Structure Improvement

Finite Element Analysis on the Lateral Crashworthiness of Car Body Structure

Topology Optimization and Lightweight Platform Development of Pure Electric Vehicle Frame-Type Aluminum Body Considering Crash Performance

Numerical Simulation and Test Validation of Vehicle Frontal Crash

Research and Analysis of Frontal Collision of Passenger Cars Based on ANSYS

Study on Vehicle Body Structure Deformation Modes in Frontal Crash

Analysis of pulse optimization of frontal crash on a specific vehicle

Modeling and Simulation of Frontal Crash Performance of a Minibus

Crashworthiness Design Optimization for an Evtol Aircraft.

Concept Analysis and Optimization of Lower Leg Impact for Car Pedestrian Protection

Vehicle safety optimization design under double standards

Optimization of the Frontal Rail Based on Composite Material

Crashworthiness analysis and multi-objective optimization of a commercial vehicle frame: A mixed meta-modeling-based method

Multi-objective optimization design of B-pillar and rocker sub-systems of battery electric vehicle

Improvement of vehicle crashworthiness for full frontal impact based on energy flow analysis

New load transfer structure to reduce body deformation in side collisions