Optimization Scheme of the Precision Separation Process of the Notched Bar Based on the Acoustic Emission Hit Energy Angle
Yujian Ren,Boyang Liu,Xiaogang Wang,Yuanzhe Dong,Jingxiang Li,Shengdun Zhao
DOI: https://doi.org/10.1016/j.tafmec.2022.103328
IF: 4.374
2022-01-01
Theoretical and Applied Fracture Mechanics
Abstract:Low-cycle fatigue cropping is a new precision separation method of metal bars with prefabricated notch effec-tively solves the problem of high active load and much material waste that occurs in the traditional separation process. However, there is still a difficult contradiction, that is, the high loading frequency improves the effi-ciency, but will reduce the quality of cross-section. The question of how to balance the loading frequency and the quality of cross-section has become an urgent problem. In this study, a new acoustic emission (AE) parameter, AE hit energy angle (AEHEA), is proposed to solve this problem. From the AE signal vitiate law in a single loading cycle, it can be seen that the interaction of high loading frequency and high crack growth rate leads to the formation of a dislocation obstacle zone, which causes the cracks originally extending in the radial direction to extend in the circumferential direction in the second half of single loading, resulting in a wider spectrum of acoustic emission sources and generating AEHEA. The results of the statistical analysis of the height variance of the cross-section show that AEHEA can well reflect the influence of the loading frequency on the cross-section quality. When AEHEA occurs, the cross-section quality decreases significantly, and the earlier AEHEA occurs, the greater the poor cross-section area. Therefore, the key to controlling the loading strategy is to suppress the occurrence of AEHEA. Before AEHEA occurs, the loading frequency should be as high as possible to improve the efficiency of cropping, and before AEHEA occurs, the loading frequency should be reduced to suppress the occurrence of AEHEA. Based on this method, three loading control strategies are developed and compared to find a better loading control strategy that balances the efficiency and quality of the cross-section.