Research on Variable Frequency-Loading Curve in Precision Cropping System with High-Speed and Centrifugal Action

Lijun Zhang,Depei Zhang,Hanxiang Wang,Shengdun Zhao,Naiming Li

DOI: https://doi.org/10.1007/s00170-018-1999-5

IF: 3.563

2018-01-01

The International Journal of Advanced Manufacturing Technology

Abstract:For carrying out the high-quality cropping cross-sections, it is critical to obtain the variable frequency-loading curve rapidly and accurately. This paper proposes a processing method on the loading force acted on the bar based on the separate treatment at the crack initiation stage and the subsection treatment at the crack propagation stage. At the crack initiation stage, the formula of stress concentration factor of V-shaped notch is given by the polygonal section assumption method when the bottom corner radius of V-shaped notch is 0.2–0.5 mm, and the critical initial load acted on the experimental bar is about 1405 N. According to the principle and characteristic of the cropping method, the critical stability-loading curve between the rotation frequency of main shaft and the crack propagation time is given and the transition curve is obtained by the data fitting method; the mutation force is zero when the bottom corner radius is 0.1915 mm. The cropping experimental results show that the critical variable frequency-loading curve, by which the cross-section roughness, the area and the eccentricity of final rupture region are all very small, is an ideal control mode compared with other frequency-loading curves mentioned in this paper.