Abstract:In this paper, we present a broadband out-of-phase power divider with high power-handling capability. The proposed device consists of several sections of double-sided parallel-strip lines (DSPSLs), a mid-inserted conductor plane, and two external isolation resistors, which are directly grounded for heat sinking. A through ground via (TGV), connecting the top and bottom sides of DSPSLs, is employed. The special metal via is realized to short the isolation resistors at full-frequency band when the odd-mode is excited. Meanwhile, it can be ignored as the excitation is even-mode. This property is efficiently utilized to improve the bandwidth. To examine the proposed power divider in detail, a set of closed-form equations are derived. Meanwhile, the power operation analysis illustrates that the proposed power divider is a good candidate for high power applications. The design charts show that the proposed device can support a wide frequency ratio range (1-1.7). Furthermore, broadband responses can be obtained when proper frequency ratios are adopted. For verification, an experimental power divider operating at 1.25/1.75 GHz is implemented. The measured results exhibit a bandwidth of 44.3% with better than 15 dB return loss and 18 dB port isolation is achieved.

Ka-Band Rectangular-Waveguide Gysel Power Divider with Low Insertion Loss and High Output Isolation

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

A Half-Mode Substrate Integrated Waveguide Ring for Two-Way Power Division of Balanced Circuit

Compact coaxial-waveguide four-way power divider with low insertion loss and high output isolation

W-band Power Divider Based on H-plane Slot Waveguide Bridge

Wideband Gysel HMSIW Power Divider with High Power-Handling Capability

An improved wideband three‐way waveguide power divider based on directional coupler for Ku band application

A Design of V-band Reconfigurable SPDT Switch/Power Divider Based on Slotted SIW

A Novel Compact Wideband Four-Way W-Band Waveguide Power Divider with Low Insertion Loss

A BROADBAND OUT-OF-PHASE POWER DIVIDER FOR HIGH POWER APPLICATIONS USING THROUGH GROUND VIA (TGV)

An Isolated Out-of-Phase 3-dB Power Divider via Waveguide-to-Microstrip Transition

A Broadband 3-Way Power Divider Based on Gap Waveguide for Ka-Band Applications

Planar Four-Way Power Divider with Stopband Rejection and Good Output Isolation

Wideband Out-Of-Phase Power Dividers With Improved Isolation Performance

Novel Design of Dual-Band Unequal Wilkinson Power Divider

Implementation of three-way power divider based on substrate integrated waveguide

Novel Dual-Band Out-of-Phase Power Divider with High Power-Handling Capability

A Novel Compact, Wideband Four-Way Wilkinson Power Divider with an Improved Isolation Topology

Design of a compact Ka-band three-way power divider

Design of a Compact Variable Waveguide RF Power Splitter for High-Power Applications

A tri-band Wilkinson power divider using extended T-shaped stubs