Abstract:The non-coaxial stacked holes caused by cutting deformation is a common problem in stack drilling, particularly for low-rigidity structure, and the non-coaxiality in carbon-fibre-reinforced plastic and aluminium (CFRP/Al) stack drilling has not been studied. Because of the non-homogeneous behaviour and poor machinability of CFRP, the non-coaxiality in CFRP/Al stack drilling is significantly different from previous studies on Al/Al stack drilling. Focusing on the non-coaxiality in CFRP/Al stack drilling, this paper proposed the mechanism of the non-coaxiality through both experiments and numerical study. Severe non-coaxiality occurrences were observed in the CFRP/Al stack drilling experiments. To explain the observation, the macroscopic mechanics theory of composite was applied to obtain the engineering constants of composite laminates, which are necessary for the numerical model. This application leads to the development of an optimized simulation model to predict the interlayer gaps and non-coaxiality. The numerical results that predict the non-coaxiality are consistent with the experiments, which verified the rationality of simulation model. Furthermore, the effect of the thrust force and clamping force on both interlayer gaps and non-coaxiality were studied. The interlayer gaps gradually increase with the increase in thrust force but decrease with the clamping force. Moreover, the thrust force has a complicated effect on the non-coaxiality. The non-coaxiality first decreases and subsequently increases with the increase in thrust force, which can be attributed to the "tilt effect" in the lower layer. In addition, the non-coaxiality increases with the clamping force in the simulation experiment range. The work in this paper enables us to understand the particularity of the non-coaxiality in CFRP/Al stack drilling and select the appropriate cutting parameters for CFRP/Al stack drilling.

Evaluation and reduction of the non-coaxiality in stack drilling using the pre-installed fasteners

The interlayer gap and non-coaxiality in stack drilling

! Investigation on the Non-Coaxiality in the Drilling of Carbon-Fibre-reinforced Plastic and Aluminium Stacks

Clamping force prediction for automatic drilling of stacked thin-walled workpieces based on finite element method

A Force Sensorless Method for CFRP/Ti Stack Interface Detection During Robotic Orbital Drilling Operations

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

Modeling Simplification for Thermal Mechanical Stress Analysis of TSV Interposer Stack

Quantitative Analysis and Improvement of Countersink Depth in Stack Drilling

Error Modeling and Compensation of Circular Motion on a New Circumferential Drilling System

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Investigation on the Countersink Errors in the Drilling of Thin-Wall Stacked Structures

An Approach to Countersink Depth Control in the Drilling of Thin-Wall Stacked Structures with Low Stiffness

Study on Tool Deflection Compensation Method Based on Cutting Force Observer for Orbital Drilling of CFRP/Ti Stacks

Numerical and theoretical approach to evaluate the clamping force and the interlayer gap extent during drilling of stacked materials

Modeling and Optimization of Bidirectional Clamping Forces in Drilling of Stacked Aluminum Alloy Plates

Numerical Study of Step Drill Structure on Machining Damage in Drilling of CFRP/Ti Stacks

Research on Variable Parameter Drilling Method of Ti-CFRP-Ti Laminated Stacks Based on Real-Time Sensing of Drilling Axial Force

Optimization Design for Countersink Depth Error Prediction and Compensation of CFRP/Al Stacks

High reliability model of mechanical response in drilling of CFRP/Al stacks

Countersink accuracy control of thin-wall CFRP/Al stack drilling based on micro peck strategy

A Theoretical Model for Predicting the CFRP Drilling-Countersinking Thrust Force of Stacks