Abstract:The non-coaxial stacked holes caused by cutting deformation is a common problem in stack drilling, particularly for low-rigidity structure, and the non-coaxiality in carbon-fibre-reinforced plastic and aluminium (CFRP/Al) stack drilling has not been studied. Because of the non-homogeneous behaviour and poor machinability of CFRP, the non-coaxiality in CFRP/Al stack drilling is significantly different from previous studies on Al/Al stack drilling. Focusing on the non-coaxiality in CFRP/Al stack drilling, this paper proposed the mechanism of the non-coaxiality through both experiments and numerical study. Severe non-coaxiality occurrences were observed in the CFRP/Al stack drilling experiments. To explain the observation, the macroscopic mechanics theory of composite was applied to obtain the engineering constants of composite laminates, which are necessary for the numerical model. This application leads to the development of an optimized simulation model to predict the interlayer gaps and non-coaxiality. The numerical results that predict the non-coaxiality are consistent with the experiments, which verified the rationality of simulation model. Furthermore, the effect of the thrust force and clamping force on both interlayer gaps and non-coaxiality were studied. The interlayer gaps gradually increase with the increase in thrust force but decrease with the clamping force. Moreover, the thrust force has a complicated effect on the non-coaxiality. The non-coaxiality first decreases and subsequently increases with the increase in thrust force, which can be attributed to the "tilt effect" in the lower layer. In addition, the non-coaxiality increases with the clamping force in the simulation experiment range. The work in this paper enables us to understand the particularity of the non-coaxiality in CFRP/Al stack drilling and select the appropriate cutting parameters for CFRP/Al stack drilling.

Numerical and theoretical approach to evaluate the clamping force and the interlayer gap extent during drilling of stacked materials

Clamping force prediction for automatic drilling of stacked thin-walled workpieces based on finite element method

Modeling and Optimization of Bidirectional Clamping Forces in Drilling of Stacked Aluminum Alloy Plates

A Force Sensorless Method for CFRP/Ti Stack Interface Detection During Robotic Orbital Drilling Operations

The Optimal Clamping Force Option for Robotic Drilling of Stacked Aluminum Sheets Based on Shell Theory

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

End Stiffness Modeling for Automatic Horizontal Dual-Machine Cooperative Drilling and Riveting System

The interlayer gap and non-coaxiality in stack drilling

Dynamic Cutting Force Modeling and Experimental Study of Industrial Robotic Boring

Predictive Model for the Interlayer Burr Height During Drilling of Stacked Aluminum Plates

High reliability model of mechanical response in drilling of CFRP/Al stacks

One-shot drilling process for thin CFRP/Aluminium alloys stacks

Research on Variable Parameter Drilling Method of Ti-CFRP-Ti Laminated Stacks Based on Real-Time Sensing of Drilling Axial Force

! Investigation on the Non-Coaxiality in the Drilling of Carbon-Fibre-reinforced Plastic and Aluminium Stacks

Quantitative Analysis and Improvement of Countersink Depth in Stack Drilling

Process modeling, joint virtual testing and construction of joint connectors for mechanical fastening by flow-drilling screws

Process parameter auto-adaptation strategy for one-up drilling of CFRP/aluminium hybrid stack

Investigation on the Countersink Errors in the Drilling of Thin-Wall Stacked Structures

An Approach to Countersink Depth Control in the Drilling of Thin-Wall Stacked Structures with Low Stiffness

Investigation on the cutting responses of CFRP/Ti stacks: With special emphasis on the effects of drilling sequences