Abstract:CFRP (Carbon Fiber Reinforced Polymer) is widely used in the aerospace, automobile and construction industries. Its non-homogeneous and anisotropic nature often results in unfavorable hole quality during the drilling process, and exit delamination is a resulting phenomenon that has received much attention. Exit delamination occurs when the drilling thrust force exceeds the critical thrust force. It adversely affects product quality and may even result in rejection. The thrust force on the chisel edge is an important component of the total thrust force, and it helps to predict the total thrust force so that delamination can be reduced or avoided. In this study, noticing that the chisel edge has a certain length, the author puts forward the novel concept of the azimuth angle on the basis of the micro analysis of the contact state between the chisel edge and the carbon fiber. In addition to the orientation angle of the carbon fiber, the azimuth angle of the cutting edge is also an important factor that affects the thrust force. A single carbon fiber may be modeled as a beam on an elastic foundation, and the prediction model of thrust force on the chisel edge is established based on the theory of bending fracture. The model can reflect the influence of the material properties, cutting tool geometry parameters (including the length of chisel edge, rake angle and blunt radius of cutting edge), drilling process parameters, and ultrasonic vibration parameters on the thrust force on the chisel edge and quantitatively explain the reduction of thrust force and improvement of drilling quality during the longitudinal ultrasonic vibration drilling. The prediction model of the thrust force presented in this work can make up for the shortages of qualitative interpretation. The law of periodic variation of the chisel edge thrust force with the azimuth angle helps in developing a deep understanding of the CFRP drilling process and the material removal mechanism. The basis is provided in order to reduce and avoid the exit delamination defects in drilling, and to reasonably and quantitatively determine the spindle speed, feed rate, and drill bit geometry parameters. The reliability of the prediction model is verified by a drilling test.

A Theoretical Model for Predicting the CFRP Drilling-Countersinking Thrust Force of Stacks

Clamping force prediction for automatic drilling of stacked thin-walled workpieces based on finite element method

A Force Sensorless Method for CFRP/Ti Stack Interface Detection During Robotic Orbital Drilling Operations

Mechanical model for predicting thrust force with tool wear effects in drilling of unidirectional CFRP

Influence of Cooling/lubrication Conditions on the Drilling Quality and Thrust Force of CFRP/Al Stacks

Optimization Design for Countersink Depth Error Prediction and Compensation of CFRP/Al Stacks

Countersink accuracy control of thin-wall CFRP/Al stack drilling based on micro peck strategy

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

High reliability model of mechanical response in drilling of CFRP/Al stacks

Modeling and Analysis of Force Prediction in Milling Process of Unidirectional Fiber Reinforced Polymer Composites

An analytical approach to cutting force prediction in milling of carbon fiber reinforced polymer laminates

Mechanics of thrust force on chisel edge in carbon fiber reinforced polymer (CFRP) drilling based on bending failure theory

Thrust Force on the Main Cutting Edge when Cutting Carbon Fiber Reinforced Plastics

! Investigation on the Non-Coaxiality in the Drilling of Carbon-Fibre-reinforced Plastic and Aluminium Stacks

A semi-analytical model for predicting tool wear progression in drilling CFRP

A Study on Drilling of CFRP/Ti Stacks: Temperature Field and Thermal Damage of the Interface Region

A prediction model of drilling force in CFRP internal chip removal hole drilling based on support vector regression

Numerical study on the heat effect on the drilling damage of Ti/CFRP stacks

Investigation of CFRP damages induced by the interface high temperature and mixed tool wear mechanism in drilling of thin-walled CFRP /Ti stacks

Predictive Model for the Interlayer Burr Height During Drilling of Stacked Aluminum Plates

Influence of Metal Chips on Drilling Quality of Carbon Fiber Reinforced Plastic and Titanium Stacks